Perle Systems DS1 - Manual (Page 88)

User Commands
88 IOLAN Device Server User’s Guide, Version 1.0
idle-timer
The amount of time, in seconds, that the idle timer will run. Use this timer to close a
connection because of inactivity. When the idle timer expires, because there has been
no exchange of data within the specified time, the Device Server will close the
connection. The default value is 0 (zero), meaning that the idle timer will not expire
(the connection is open permanently). The maximum value is 4294967 seconds. The
User Idle Timer will override the Line Idle Timer , with the exception reverse Telnet
sessions.
ip-host
When the User Service is set to Telnet or TCP_clear , the target host IP address. If
255.255.255.255 is specified in the configuration, the user will be prompted for an IP
address or hostname. If no IP address is specified, the Host IP value in the
Default User
configuration will be used. The default is 0.0.0.0 .
language
You can specify whether a user will use English or Customlang as the language that
appears in the Menu, CLI, or WebManager. The Device Server supports one custom
language that must be downloaded to the Device Server; otherwise,
Customlang
defaults to English.
level
The access that a user is allowed:
z Admin—The admin level user has total access to the Device Server. You can
create more than one admin user account but we recommend that you only have
one. They can monitor or configure the Device Server through the CLI or Menu.
z Normal—The Normal level user has limited access to the Device Server. Limited
CLI commands and Menu access are available with the ability to configure the
user’s own configuration settings.
z Restricted—The Restricted level user can only access predefined sessions or
access the Easy Port Access menu. Can only view or monitor the Device Server
using CLI commands to display information about the Device Server.
z Menu—The menu level user will only be able to access predefined session or
access the Easy Port Access menu. The Easy Port Access allows the user to
connect to the accessible line without disconnecting their initial connection to the
Device Server. Does not have any access to CLI commands.
password
The password the user will need to enter to login to the Device Server.
line-access
Specifies the user access rights to each Device Server device line. Options are:
z Read/Write—Users are given read and write access to the line.
z Read In—Users are given access to read only outbound data, data that is going
from the Device Server to the device.
z Read Out—Users are given access to read only inbound data, data that is going
from the device to the Device Server.
Users can read data going in both directions by selecting both the Read In and Read
Out options.
service
The type of service that the user will use.