Enhancing sacd playback, Dimming the display, Using other functions 09 – Pioneer VSX-59TXi User Manual

Page 77

Advertising
background image

Using other functions

09

77

En

Note

• If you change the source using the input buttons (or

front panel

INPUT SELECTOR dial), the system

returns to normal playback.

Enhancing SACD playback

You can get more detail from SACDs by maximizing the
dynamic range (during digital processing) using the
SACD gain feature.

1

Press OPTION repeatedly until SACD GAIN shows

in the display.

With the remote, you may need to press

on the

Home menu (

) first before reaching the receiver menu

screen shown below (use the

/ (cursor left/right)

soft keys to go to the previous/next menu screen).

2

Use the (OPTION) +/– buttons to switch the SACD

gain between 0dB and 6dB.
For most SACD sources, selecting

6dB will result in high

sound quality and greater detail. The level will be
adjusted automatically for playback at the same volume.

3

Press ENTER to confirm.

Note

• You shouldn’t have any problems using this feature

with most SACD discs, but if the sound distorts, it is
best to switch the gain setting back to

0dB.

Using the A/D converters to give
greater definition to 2-channel sound

This receiver has high-quality 192kHz (24bit) A/D
converters that can be used in parallel to provide greater
resolution of DSP processing with analog 2-channel
sources. There are two ways to get 192kHz A/D
conversion:

1

Switch the SD:1 NORMAL Stream Direct mode

on.
See Using the Stream Direct mode on page 47 for more on
this.

2

Select the STEREO listening mode and switch off

any other sound processing features.
These features include:

• Midnight/Loudness (page 52)

• Digital Noise Reduction (page 53)

• Dynamic Range Control (page 94)

Also, make sure you also switch the multichannel input
to

2 CHANNEL in Selecting USB and multichannel analog

input channels on page 49.

Dimming the display

You can choose between four brightness for the front
panel display. Note that when selecting sources, the
display automatically brightens for a few seconds.

From the remote control receiver menu, press

DISPLAY DIMMER repeatedly to change the
brightness of the front panel display.

You may need to press

on the Home menu (

)

first before reaching the receiver menu screen shown
below (use the

/ (cursor left/right) soft keys to go to

the previous/next menu screen).

RECEIVER

Receiver

MIDNIGHT

DIGITAL NR

TONE

LOUDNESS

OPTION

+

CH LEVEL

+

PHONES

SP SYSTEM

A/B

SIGNAL
SELECT

VIDEO

SELECT

TAPE2

MONITOR

STREAM

DIRECT

SETUP

MIC

SB CH

MODE

DIGITAL IN

S-VIDEO

VIDEO

VIDEO INPUT

AUDIO

L

R

MIDNIGHT

TONE

OPTION

DIGITAL NR

CLASS

STATION

MULTI ROOM & SOURCE

CONTROL

ON/OFF

TUNER

ACOUSTIC

CAL.

RECEIVER

RECEIVER

3/4

SB CH

MODE

INPUT

STATUS

INPUT

ATT

SPEAKER

A/B

VIDEO

SELECT

TAPE2

MONITOR

DISPLAY
DIMMER

RECEIVER

TV

CONT

Advertising