Panasonic SC-AK340 - Manual (Page 5)

5
RQT8043
RQTV0066
LANG - 5
LANG - 4
FRANÇAIS
DANSK
DEUTSCH
Optional antenna connections Optional antenna connections
Use outdoor antenna if radio reception is poor.
Note:
Disconnect the outdoor antenna when the unit is not in use. Do not use the outdoor antenna during a lightning storm.
FM outdoor antenna AM outdoor antenna
For Europe
Rear panel of
this unit
For others
Rear panel of
this unit
FM outdoor antenna (not included)
75 Ω coaxial cable
(not included)
Shield braid
Core wire
For the United Kingdom
Antenna plug adaptor
(included)
30 mm
15 mm
For Europe
Rear panel of
this unit
For others
Rear panel of
this unit
AM outdoor antenna (not included)
AM loop antenna
(included)
5-12 m
• Disconnect the FM indoor antenna.
• The antenna should be installed by a competent
technician.
• Run a piece of vinyl wire horizontally across a window or
other convenient location.
• Leave the loop antenna connected.
Step 2
- Inserting batteries into the remote control - Inserting batteries into the remote control
AA/R6/LR6
■ Batteries
• Insert so the poles (+ and –) match those in the remote control.
• Remove if the remote control is not going to be used for a long period of time.
Store in a cool, dark place.
• Replace if the unit does not respond to the remote control even when held
close to the front panel.
• Do not use rechargeable type batteries.
• Mishandling of batteries in the remote control can cause electrolyte leakage,
which may cause a fi re.
• If electrolyte leaks from the batteries, consult your dealer.
Wash thoroughly with water if electrolyte comes in contact with any part of
your body.
Do not:
• mix old and new batteries.
• use different types at the same time.
• heat or expose to fl ame.
• take apart or short circuit.
• attempt to recharge alkaline or manganese batteries.
• use batteries if the covering has been peeled off.
• put heavy objects on the remote control.
• spill liquids onto the remote control.
■ Use
Aim at the remote control sensor, avoiding obstacles, at a maximum range
of 7 m directly in front of the unit.
Refer to page 6 for the remote control sensor position.
Step 3
- DEMO function - DEMO function
When the unit is fi rst plugged in, a demonstration of its functions may be shown
on the display.
If the demo setting is off, you can show a demonstration by selecting “DEMO
ON”.
Press and hold [DISPLAY, –DEMO].
The display changes each time the button is held down.
NO DEMO (off)
Ô DEMO ON (on)
While in standby mode, select “NO DEMO” to reduce power consumption.
Note:
DEMO function cannot be turned on when Dimmer is on.
RQTV0066-B.indd 5 RQTV0066-B.indd 5 11/16/05 9:36:44 AM 11/16/05 9:36:44 AM