Palm T5 - Manual (Page 641)

Tungsten™ T5 Handheld 619
Model Name/Number: Tungsten T5
Manufacturer’s Name: palmOne
Manufacturer’s Address: 400 N. McCarthy Blvd.
Milpitas, 95035-5112
Conforms with the following specifications:
• EN 55024: 1998 (Emissions & Immunity)
• EN55022:1998, CISPR 22 1997, Class B Radiated and Conducted Emissions
• IEC 61000-4-2, A1 1998-01, ESD Immunity, 4kV Contact, and 8kV Air Discharge
• IEC 61000-4-3: 1995 RF Immunity, 80-1000MHz, 3V/M, 1kHz, 80% A.M.
• ENV 50204:1996, RF Immunity, 895-905MHz, 3V/m, 200Hz, 50% AM
• IEC 61000-4-4: 1995 EFT Immunity, 1kV on AC port, 5/50nSec, 5kHs Rep. Freq.
• IEC 61000-4-5: 1995 Surge Immunity, 1.2/50uSec, 2kV(peak), Common Mode, 1kV(peak) Differential Mode
• EN61000-4-6:1996, Conducted Immunity, 150kHz-80MHz, 3V RMS, 1kHz, 80% AM
• IEC 61000-4-11: 1994, 100% Voltage Dip 0.5 period, 30% Dip 25 periods and >100% Dip 250 periods
Authorized palmOne Representative: David Woo
Senior Compliance Engineer
Date: November 3, 2004
Battery Warning
Do not mutilate, puncture, or dispose of batteries in fire. The batteries can burst or explode, releasing
hazardous chemicals. Discard used batteries according to the manufacturer’s instructions and in accordance
with your local regulations.
Warning – Explosion Hazard
• Substitution of components may impair suitability for Class I, Division 2;
• When in hazardous location, turn off power before replacing or wiring modules, and,
• Do not disconnect equipment unless power has been switched off or the area is known to be non-
hazardous.