Philips VCR 462 - Manual (Page 10)

...
...
POWER
CBL/DSS VCR TV
EJECT MUTE
MENU EXIT/STATUS CLEAR
VCR PLUS+
/ENTER LIGHT
F.ADV
PAUSE/STILL
1 2 3
4 5 6
7 8 9
100 0 GO-TO
MEMORY INDEX
VAR. SLOW
REMOTE LOCATOR
SKIP
VCR/TV SPEED SEARCH SLOW
TRACKING
STOP
REW FF
PLAY
VOL CHANNEL
/OTR REC
10 Turning on Your VCR
TO SELECT PUSH NO. SHOWN
1 ENGLISH (ON)
2 ESPAÑOL
MAKE SELECTION OR
PUSH MENU TO CONTINUE
2
3
5
Before turning on your VCR, make sure there are batteries in the
remote control. Details are on page five. Make sure the VCR, TV,
and Cable Box/DSS Receiver (if applicable) are connected. Details
are on pages six - nine. If you are going to set up the Controller
now, connect the Controller before you begin. Details are on
page 42. If you plan to set up the VCR Plus+ Programming System
now, complete the charts on page 38 before you begin.
1
Turn on the TV. Set it to channel 3 or 4, whichever the
CH3/CH4 switch on the back of the VCR is set to.
2
Press the VCR button, then press the POWER button.
The VCR will come on and the menu shown below will appear.
3
Press the Number 1 button to select English on-screen dis-
plays. (ON) will appear to the right of ENGLISH on-screen. Or,
press the Number 2 button to select Spanish on-screen dis-
plays. (SI) will appear to the right of ESPAÑOL on-screen.
4
1 Turn on the TV.
4
Press the MENU button. The menu shown below will appear,
giving you the option to set up the Cable Box Controller now.
TO SELECT PUSH NO. SHOWN
1 ENGLISH (ON)
2 ESPAÑOL
MAKE SELECTION OR
PUSH MENU TO CONTINUE
CABLE BOX CONTROLLER
OFF
TO SELECT PRESS NUMBER
1 ON
2 OFF
TO CONTINUE PUSH MENU
TO END PUSH EXIT
5
If you do not want to set up the Cable Box Controller
now, press the Number 2 button to leave the Cable Box
Controller turned OFF. Proceed to step 6 on page 11. You
may set up the Controller later by following the instructions on
pages 42 - 46.
If you do want to set up the Cable Box Controller now, press the
Number 1 button to turn the Cable Box Controller ON. Press the
MENU button, then follow steps 4 - 6 on page 14. When you finish
setting the clock, complete steps 7 - 11 on page 44. When you finish
setting up the Cable Box Controller, go to step 9 on page 11.
• Leave the Cable Box turned on if
you plan to set up the Cable Box
Controller now.
• Set the Cable Box to a channel
other than channel 09.
Helpful Hints