Philips VCR 462 - Manual (Page 6)

CH3 CH4
RF OUT
ANT.IN
AUDIO
CABLE BOX
VIDEO
IN OUT IN OUT
R
L
OR
CH3 CH4
RF OUT
ANT.IN
AUDIO
CABLE
BOX
VIDEO
IN OUT IN OUT
R
L
75 ⍀ ANT / CABLE
OR
75 ⍀
ANT /
CABLE
6 Hookups Without a Cable Box
The basic VCR/TV connection – antenna/cable to VCR to TV – is shown below. If you have a Cable Box or
a Digital Satellite System Receiver, please refer to pages eight-nine. After you hook up the VCR, please go
to page 10 to turn on the VCR. (The VRX462 is illustrated here. The VRX442 has single AUDIO IN/OUT
Jacks.)
ANTENNA IN
Jack
(on back of TV)
Cable
(75 ohm)
Antenna
Indoor/Outdoor
(300 ohm)
1
Disconnect the antenna or cable from your TV.
2
Connect the antenna or cable to the ANT(enna) IN Jack on the back of the
VCR.
Cable
(75 ohm)
Antenna
Indoor/Outdoor
(300 ohm)