Panasonic MC-V7319 - Manual (Page 34)

Replacing Belt
- 34 -
Felt Packing
Cale en feutre
Empaquetadura
de fieltro
Lift Agitator Up
Soulever l’agitateur
Unidad del agitador
Belt Cover
Couvercle de
la courroie
Cubierta de
la banda
Install
New Belt
Poser la
nouvelle
courroie
Instalación
de la correa
Motor Shaft
Arbre d’entraînement
du moteur
Eje del motor
Selector alfombra-piso
Carpet/Bare
Floor
Sélecteur
tapis/plancher
Groove
Ouverture
Ranura
End Cap
Bouchon
Tapa de
extremo
➢ Replace belt whenever a burning
rubber smell caused by excessive
slippage occurs.
➢ Remove lower plate.
➢
Lift rear belt cover and remove felt
packing.
➢ Remove agitator by carefully lifting
out.
➢ Remove worn or broken belt.
➢
Clean agitator.
➢ Loop new belt (Panasonic Type UB8
only) around motor shaft and
agitator pulley.
➢ Reinstall agitator back into nozzle
housing grooves.
➢ Close rear belt cover and reinstall
felt packing.
➢ After reinstalling the agitator, turn it
by hand to make sure that belt is not
twisted or pinched and that all
rotating parts turn freely.
➢
Reinstall lower plate.