Planet Technology WAP-4000A - Manual (Page 9)

PLANET WAP-4000A User Manual
- 5 -
Chapter 3 Configuring the Wireless Access Point
WAP-4000A can be configured via web browser. It is strongly recommended to configure and
manage WAP-4000A using a wired LAN computer.
3.1 Configure through Web Browser
Web configuration provides a user-friendly graphical user interface (web pages) to manage
your WAP-4000A. An AP with an assigned IP address (e.g. http://192.168.1.1) will allow you to
monitor and configure via web browser (e.g., MS Internet Explorer or Netscape).
1. Open your web browser.
2. Enter the IP address of your WAP-4000A in the address field (default IP address is
http://192.168.1.1 ). Please note that your PC’s IP address should be on the same IP
subnet of the WAP-4000A. For example, you can configure your PC’s IP address to
192.168.1.2 if WAP-4000A is with IP 192.168.1.1.
3. A User Name and Password dialog box will appear. Please enter your User Name and
Password here. Default User Name and Password are both “admin”. Click Ok.
Figure1
4. Then you will see the WAP-4000A web configuration page.
3.2 Wizard
Setup wizard provides a simple way to configure your WAP-4000A. Clicking Wizard button on
top panel of WAP-4000A’s web page, Setup Wizard will pop up as below.