Parkinson Cowan SIG 504 - Manual (Page 29)

General information
Moving your appliance
You may damage some soft or badly fitted floor coverings when you
move the appliance. The floor covering under the appliance should be
securely fixed so it does not ruck up when you move the appliance
across it. Alternatively you could remove the floor covering.
To move the appliance open the second oven door. Raise the
appliance off its front feet by lifting it from inside the oven. Pull the
appliance forward. When you replace the appliance push it back to the
stop and make sure there is the same gap at each rear corner.
Connecting to the electricity supply
The plug supplied with the appliance can be fitted directly to a suitable
three pin earthed socket.
If you have to change the fuse replace it with a 3 amp fuse which has
been ASTA approved to BS 1362.
Do not use the plug until you have put the fuse cover back on. If the
fuse cover is lost you can get a replacement from an electrical retailer.
The correct replacement can be identified by marking or colour coding.
S I G 5 0 4
29
General information
For your safety
Do not try to disconnect the appliance from the gas supply if the
supply pipe does not have a bayonet connection, as described in
the installation instructions. If this is the case contact the person
who installed the appliance.
For your safety
This appliance must be earthed and protected by a 3 amp fuse.
For your safety
Do not block any of the appliance vents.
Never line any part of the appliance with aluminium foil.
Do not let items which can catch fire or electric mains leads such
as kettle flexes trail over any part of the appliance.