Printek MTP300 - Manual (Page 16)

Daily Operation
Enter Button – Used in printer configuration menus to advance to the next
setup feature. May also be used to print the settings and
connection information for the currently selected interface.
Power Indicator – ON indicates that the power is on and that the printer is in
normal power mode. SLOW FLASH indicates that the
printer is in Setup mode and not accepting data. SHORT
FLASH indicates that the printer has entered the power
saving standby mode and will wake upon receipt of data or
when the Power Button or Paper Feed Button is
pressed.
Wireless Indicator – Indicates that an optional Bluetooth or Wi-Fi interface is
installed, enabled and is currently connected or receiving
data.
MCR Indicator – Indicates that the optional Magnetic Card Reader has been
enabled and is ready for the user to swipe a card.
Error Indicator – Indicates that an error has occurred as described on the
LCD Display.
Battery Indicator – ON indicates that the battery is currently being charged.
FLASHING indicates that the battery capacity is low and
the battery needs to be recharged.
Removing Printed Output
In most cases, the host application program will issue a Form Feed that will eject the paper so that all the
printed information is fed out of the printer and the receipt or label is ready to be torn off. If all the printing is
not yet out of the printer and the host has finished sending data to the printer, the paper may be positioned for
tearing by simply pressing the Paper Feed Button.
To tear the paper, pull the paper against the tear bar at a slight angle as shown in Figure 6, and then continue to
pull the paper in the direction shown to tear it off.
Figure 6 - Tearing Off Printed Output
10