Planet Technology XRT-501 - Manual (Page 3)


1. Requirements
l DSL or Cable modem for broadband Internet access.
l Network cables. Use standard 10/100/1000Base-T network (UTP) cables with
RJ45 connectors.
l TCP/IP network protocol installed on each PC.
2. Before Startup
2.1 Physical Installation
Setup your network as shown in the setup diagram below
1. Use standard LAN cables to connect PCs to the Switching Hub ports on the
XRT-501, or you can directly connect PCs to XRT-501, you may use 10Base-T,
100Base-TX, or 1000Base-T connections, and all connection types can be used
simultaneously.
2. If required, connect any port to a normal port on another Hub, using a stan-
dard LAN cable. Any LAN port on the XRT-501 will automatically function as an
“Uplink” port when required.
3. Connect the DSL or Cable modem to the WAN port on the XRT-501. Use the
cable supplied with your DSL/Cable modem. If no cable was supplied, use a
standard cable.
4. Connect the supplied Power Adapter and power on.
5. Check the LEDs