Pioneer MVH-P8200BT - Manual (Page 45)

Troubleshooting
Common
Symptom Cause Action (Refer-
ence page)
The power will
not turn on.
The unit will
not operate. Leads and con-
nectors are incor-
rectly connected. Confirm once more
that all connec-
tions are correct.
The fuse is
blown. Rectify the cause
and then replace
the fuse. Be sure to
install a fuse with
the same rating.
Noise and/or
other factors are
causing the built-
in microproces-
sor to operate in-
correctly. Press RESET. (Page
7)
Operation with
the remote
control is not
possible.
The unit does
not operate
correctly even
when the ap-
propriate re-
mote control
buttons are
pressed. Battery power is
low. Load a new battery.
There is no
sound.
The volume
level will not
rise. Cables are not
connected cor-
rectly. Connect the cables
correctly.
The aspect
ratio is incor-
rect and the
image is
stretched. The aspect ratio
setting is incor-
rect for the dis-
play. Select the appro-
priate setting for
your display. (Page
38)
There is no
image dis-
played. The parking
brake cable is
not connected. Connect the park-
ing brake cable,
and apply the park-
ing brake.
The parking
brake is not ap-
plied. Connect the park-
ing brake cable,
and apply the park-
ing brake.
Symptom Cause Action (Refer-
ence page)
The image dis-
played stops
(pauses) and
the unit cannot
be operated. The data could
no longer be
read during play-
back. Stop playback
once, and start
playback again.
There is no
sound.
The volume
level is low. The volume level
is low. Adjust the volume
level.
The attenuator is
on. Turn the attenuator
off.
The sound and
video skip. The unit is not
firmly secured. Firmly secure the
unit.
NO XXXX ap-
pears when a
display is chan-
ged (
NO TITLE,
for example).
There is no text
information em-
bedded. Switch the display
or play another
track/file.
Sub-folders
cannot be
played back. Folder repeat
play has been se-
lected. Select the repeat
range again.
The repeat
range changes
automatically. Another folder
was selected dur-
ing repeat play. Select the repeat
range again.
Track search or
fast forward/re-
verse was per-
formed during
file repeat play. Select the repeat
range again.
Problems during iPod playback
Symptom Cause Action
The iPod does
not operate
correctly. The cables are in-
correctly con-
nected. Disconnect the
cable from the
iPod. Once the
iPod's main menu
is displayed, recon-
nect the iPod and
reset it.
The iPod version
is old. Update the iPod
version.
Error messages
When you contact your dealer or your nearest
Pioneer Service Center, be sure to note the
error message.
En
45
English
Appendix
Additional Information