Profoon Telecommunicatie TAM-60X - Manual (Page 9)

PERSONAL MEMO:
1. Press and hold the MEMO button for approximately 2 seconds.
2. A beep will sound and the countdown timer will appear in the display.
The recording time of the memo must be less than 30 seconds and more than
3 seconds.
3. Record your memo into the microphone.
4. Release the MEMO button to stop the recording.
TWO-WAY RECORDING:
1. During telephone talking, press and hold 2WAY button for 2 seconds until a
long beep is heard.
2. Two-way recording is started.
3. Press the STOP-button to end the recording.
PLAY BACK:
The display's message counter will blink when the unit has recorded new messa-
ges, including memo’s and 2-way recordings. If the message counter is not blin-
king, then that is the number of messages that have been recorded previously,
but not deleted.
1. Make sure the volumecontrol is adjusted as desired.
2. If new messages have been recorded, press the PLAY button to hear
only the new messages. If no new messages have been recorded, press the
PLAY button to hear the previously heard messages that were not
deleted.
- To repeat a message while you are listening to it, simply press the RING/
button.
- Repeatedly press this button to skip back to previous messages.
- To skip a message while you are listening to it, press the CODE/
button
and the next recorded message will play.
- To pause the ICMS, press and release the PLAY button, the unit will
pause playback and "PA" will blink in the display. To continue playback,
press and release the PLAY button again.
4. To stop playback, press the STOP button and the unit will save the previous
messages.
After playing the messages, the display's message counter will show the total
messages received.
DELETE:
To erase a single message while playing it back, press the DEL button and the
unit will delete the current message and play the next message.
To delete all the messages, press and hold the DEL button while in the idle
mode (messages not playing). The unit will beep and the message counter will
revert back to "00"
9