PYLE Audio PLDVD199XM - Manual (Page 16)

RADIO OPERATION
SWITCHING TO RADIO MODE
Press MOD on the front panel or MODE
on the remote control to select radio
mode, the radio mode appears in the
display together with the memory band
and frequency.
SELECTING THE FREQUENCY BAND
During radio mode, shortly press
BND/MEN button on the front panel or
BAND (MENU) button on the remote
control to select the desired band. The
reception band will change in the following
order:
SELECTING STATION
During radio mode, shortly press
CH/TUN/TRK
button on the front
panel or button on remote control to
increase frequency by one step of channel
spacing, and shortly press CH/TUN/TRK
on the front panel or button on
remote control to decrease frequency by
one step of channel spacing. Hold
CH/TUN/TRK
/ buttons on the
front panel longer or press / buttons
on the remote control for fast tuning. The
frequency is updated correspondingly on
display.
LOCAL/DISTANT
Press ST/XM-MOD button on the front
panal or remote control for several
seconds to select between local and
distant stations.
Local setting for reception of strong
station, and a distant setting for reception
of weaker stations. This function is effect
during AUTO SEEK operation.
AUTOMATIC MEMORY STORING &
PROGRAM SCANNING
- Automatic memory storing
Press and hold AMS button on the
front panel or on the remote control for
several seconds, the radio searches
from the FM1 the initial frequency and
checks the signal strength until one
cycle search is finished. And then 6
16
OPERATION
strongest stations are stored into the
corresponding preset number button.
- Program scanning
Press AMS button shortly to scan preset
station.
STATION STORING
Press any one of the preset buttons (1 to
6) on the front panel to select a station,
which had been stored in the memory.
Press this button for several seconds,
current station is stored into the number
button.
MONO/STEREO
Press ST/XM-MOD button on the front
panal or remote control shortly to select
mono or stereo mode. You can sometimes
improve reception of distant stations by
selecting mono operation.
SCAN
Press ENT/MUT button on the front panel
shortly to set the function to scan mode,
which scanning to higher frequency station
with receivable signal and keep on each
station for several seconds.
XM OPERATION
SWITCHING TO XM MODE
Shortly press MOD button to select XM
mode.
SELECTING USER-PRESET CHANNEL
In XM mode, the XM user-preset channel
group (3 channels) is toggled cyclically
through the group by quickly pressing the
BND/MEN button.
The channel will change in the following
order:
SELECTING CHANNEL UP/DOWN
Press the CH/TUN/TRK
button or
CH/TUN/TRK button to select the
channel up or down.
SEARCHING SCHANNEL
When the AMS button is shortly pressed,
the unit searches for each user preset
channel from XM1, XM2 to XM3. When
an available channel is detected, the
FM1 FM2 FM3 AM1 AM2
XM1 XM2 XM3