PYLE Audio PLDVD199XM - Manual (Page 17)

2. Use CH/TUN/TRK button or
CH/TUN/TRK button to select
hundred digit.
3. Press ST/XM-MOD button again to
confirm entry of the hundred digit and
the 10s digit is flashing on/off.
4. Use CH/TUN/TRK button or
CH/TUN/TRK button to select 10s
digit.
5. Press ST/XM-MOD button again to
confirm entry of the 10s digit and the
10s digit is flashing on/off.
6. Press ST/XM-MOD button again to
confirm entry of the 1s digit.
7. Press BND/MEN button to direct tune.
DISC (DVD/VCD/CD/MP3) OPERATION
STOPPING PLAY
- Briefly press the button on the front
panel or AMS (STOP) button on the
remote control to stop the unit
playback, when the
button is
pressed, normal playback will
continue.
- Press button or AMS (STOP) button
twice to stop the playback and go
back to initial Track/Chapter.
RAPID FORWARD/RAPID REVERSE
Press
& during play. Each time the
button is pressed, the speed of rapid
forward/reverse changes according to
the disc as follow:
FOR DVD/MP3:
FOR VCD/CD:
SKIPPING TRACK
Press CH/TUN/TRK
/ buttons
on the front panel or / buttons on
the remote control during playback.
Press
or to skip to next track,
and or to back one track.
Note: For some VCD 2.0 dics
(PBC-playback control),
/ or
/ buttons may be unavailable.
SLOW MOTION PLAY
Press / button on the remote control
17
OPERATION
Normal Playback 2X 4X 6X 8X
Normal Playback 1X 2X 3X 4X
channel will be held at that preset number
and played about 5 seconds. After that,
it will search for another available channel.
STORING PRESET CHANNELS
The preset buttons can be used to store
6 channels for convenient access to your
favorite channels.
- Programming channels
1. Select the desired channel you want to
store in memory.
2. Press and hold one of the preset buttons
for more than 2 seconds until the
corresponding preset button number
appears. Repeat steps 1 and 2 to
program additional channels.
- Quick tuning
Press one of the six preset buttons
shortly to select a preset channel directly.
XM MODE SELECTION
Press ST/XM-MOD button to switch
CATEGORY mode, DIRECT TUNE mode,
or NORMAL mode. It is used as the
selection of each:
When Category mode is engaged, the
“CATEGORY” function is turned on in the
display. When Category mode is released,
the “CATEGORY” function is turned off.
When Direct mode is engaged, “DIRECT”
of alphanumeric display is turned on.
Select category and tune UP/DOWN
within selected category
Use D.UP/CAT button or D.DN/CAT
button to select desire Category and press
BND/MEN button. In Category mode,
channels can be tuned within the same
category.
- When the user wishes to search by
Category, press ST/XM-MOD button
until it goes into Category search mode.
- Press M6 button or M5 button up and
down to get to the desired category.
- To change channels, press ST/XM-MOD
button again to Normal mode, and then
press CH/TUN/TRK
button or
CH/TUN/TRK button to select the
channel up or down.
How to direct tune
1. In direct mode, display shows DIRECT
and “000” channel number. (Hundred
Digit flashing on/off)
Normal Category mode Direct Tune