PGS K-40 - Manual (Page 17)

THIS CONNECTION WILL REQUIRE LEAK CHECK
UPON ASSEMBLY COMPLETION. (see Fig. 18).
8. Attach feed line mounting clip to pedestal using #8
X 1/2" S.S. machine screw. BE SURE TO ALIGN
SCREW TO AVOID STRIPPING THREADED
NUTSERT.
9. Remove "Sure Start" Ignitor module from the
underside of control panel by unscrewing black ring.
Remove rear cover of module and insert a fresh AA
alkaline battery into unit (included). Plug the end of
the ignitor wire lead to the electronic ignitor module.
NOTE: On the K-40, the wire is fed through the lower
casting and connects to the electrode lead, which is
attached to the burner. On the K-30, the wire attaches
below the casting onto the electrode lead. Reinstall
the black cover and insert the module back into the
control panel (see Fig. 8). Be certain to put the red
protective moisture cap on the button and secure the
black plastic ring.
Figure 9 Installing Shelf Bracket
On portable models, this shelf, in the upright position,
is to be used as a handle to move the barbecue
around. It is a sturdy handle properly hinged securely
into place (see Fig. 10).
DO NOT OVER-TIGHTEN PLASTIC RING.
Figure 8 Ignition Module Assembly
Figure 10 Hinging Shelf
NOTE: Replace battery when sparking sound either
stops or noticeably slows down or every six months,
whichever occurs first. If you are not going to use your
grill for more than 30 days, remove the battery.
Reinstall when you are ready to use your grill again.
11. Attach two control valve knobs to end of valve
stems located in center of control panel. White mark
should be pointing up to the OFF position.
FINISH ASSEMBLY
SIDE SHELF ASSEMBLY
1. Be sure to remove plastic protective film. Place
"Flare Guard" rock grate so that feet (bent ends) face
down.
10. Install the left and right shelf brackets to the lower
casting of your barbecue, using the four 1/4 X 20 X
3/4" hex bolts, secure with four 1/4" lock washes and
four 1/4" hex nuts to hold each bracket (see Fig. 9).
Attach shelf to the brackets by inserting the threaded
screws on the shelf through the lower slots on the
brackets. Let the shelf hang down. Attach the 10-32
Hex Nuts (see Fig. 10).
2. Place ceramic "Moon Rok II" on rock grate by
evenly placing side by side. DO NOT COVER HOLES
IN THE "FLARE GUARD" ROCK GRATES. Do not
put more than one layer of rock on the grates (see
Fig. 11).
17