PGS K-40 - Manual (Page 8)

LP-Gas Tank Specifications:
GRILL HEAD: Entire BBQ grill (lid & pit) that can be
mounted on a variety of options. Weight (filled) 40 lbs. (18.14 kg)
Capacity 4.5 gallons
8
Diameter (outside) 12 1/8" (30.8 cm)
Height 18" (45.7 cm)
GRILL MOUNT: Supports gas grill head, can be a
post mount, pedestal mount (stationary or mobile) or
built in frame inserted in a masonry enclosure.
Connection TYPE II Couple Safe
GRILL UPPER CASTING: Top (lid) of gas grill head,
made of aluminum and powder coated black.
GRILL LOWER CASTING: Bottom (pit) of gas grill
head made of aluminum and powder coated black.
FEED LINE
BASE: Stationary or designed to be used with wheels
made of aluminum and powder coated black.
RACK: Warming area made of stainless steel and
removable.
LP Tank, Hose and Feedline Assembly
COOKING GRIDS: Area most used for grilling, with
LP REGULATOR TO
TANK CONNECTION variably spaced grid tines for flexibility.
ROCK GRATES: Solid stainless steel plates with
square holes in them for heat convection.
MOON ROK II: The highest quality grill rock for great
BBQ flavor and flare control.
TYPE II FILL ADAPTER
TYPE II “COUPLE SAFE” COLLAR BOX: Stainless steel box between grill
mount and grill head.
QUICK COUPLE VALVE
TYPE II LP Connections
IGNITOR MODULE: Battery powered ignition for
instant spark.
NATURAL GAS MODELS VALVE: Device used to control amount of gas (and
heat) grill produces.
Your PGS gas grill has been designed and produced
for outdoor use only! Every gas-burning appliance
produces carbon monoxide and should not be allowed
to accumulate in confined areas. DO NOT OPERATE
YOUR PGS GAS GRILL INSIDE A HOME, GARAGE,
RECREATIONAL VEHICLE, BOAT/HOUSE BOAT,
OR ANY OTHER ENCLOSED AREA.
ORIFICES: Openings at end of valve that restrict
amount of gas going to BBQ.
VENTURI: Banana shaped tube that allows gas to
flow from the valve to the burner.
FEEDLINE: Aluminum gas line from back to grill
mount to bottom of valve. Used only on models that
include pedestal.
When choosing a location for your grill, you must
locate it at least 30" away from any combustible
material and out of traffic paths. The grill and its
individual shutoff valve must be disconnected from the
gas supply piping system during any pressure testing
of that system at test pressures in excess of 1/2 psig
(3.5kPa).
HINGE PINS AND COTTER PINS: Hinge pin goes
through lower and upper casting with cotter pins
permanently holding.
GASKET: Insulator between pedestal and base.
The grill must be isolated from the gas by closing its
valves during any pressure testing of the gas supply
piping system at test pressures equal to or less than
1/2 psig (3.5kPa).
WATER COLUMN (W.C.): A measurement of gas
pressure.
DEFINITION OF KEY TERMS