Panasonic SC-BT330 - Manual (Page 29)

Radio
Playback
29
VQT2M13
Radio Listening to the Radio
Up to 30 stations can be set.
1
Press [RADIO] to select “FM”.
2
Press [STATUS] to select the position to
start the auto preset search.
LOWEST:
To begin auto preset with the lowest frequency (FM87.9 or
FM87.5).
CURRENT:
To begin auto preset with the current frequency.*
* To change the frequency, refer to “Presetting stations
manually”.
3
Press and hold [OK].
Release the button when “AUTO” is displayed.
The tuner starts to preset all the stations it can receive into
the channels in ascending order.
≥ “SET OK” is displayed when the stations are set, and the radio tunes to the
last preset station.
≥ “ERROR” is displayed when automatic presetting is unsuccessful. Preset
the stations manually.
Preparation
Select a radio broadcast.
1 Press [RADIO] to select “FM”.
2 Press [SEARCH
6] or [SEARCH5] to select the
frequency.
≥ To start automatic tuning, press and hold [SEARCH6], [SEARCH5]
until the frequency starts scrolling. Tuning stops when a station is found.
1
While listening to the radio broadcast
Press [OK].
2
While “P” is flashing on the display
Press the numbered buttons to select a
channel.
To select a 1-digit number
e.g., 1: [1]
B [OK].
To select a 2-digit number
e.g., 12: [1]
B [2]
≥ A station previously stored is overwritten when another station is stored in
the same channel preset.
1
Press [RADIO] to select “FM”.
2
Press the numbered buttons to select the
channel.
To select a 1-digit number
e.g., 1: [1]
B [OK].
To select a 2-digit number
e.g., 12: [1]
B [2].
Alternatively, press [ W, X] or [2, 1].
∫ Display on the main unit
TUNED/STEREO: Displayed when receiving stereo
broadcasting
TUNED: Displayed when receiving monaural
broadcasting or monaural sound is
selected.
∫ FM frequency step
Main unit:
The factory setting is set to 0.2 MHz, it can be changed to
receive broadcasts allocated in 0.1 MHz. You may need to
change this setting if the tuner seems to skip over the correct
frequency for stations in your area.
1 Press [SELECTOR] to select “FM”.
2 Press and hold [SELECTOR].
After a few seconds the display changes to show the
current lowest frequency. Continue to hold the button
down. The lowest frequency changes and the step is
changed.
To return to the original settings, repeat steps 1 and 2.
≥ After changing the setting, previously preset frequencies will be cleared.
Preset them again.
Presetting stations
automatically
Presetting stations manually
Listening/confirming the preset
channels
∫ If noise is excessive
Press [AUDIO] to display “MONO”.
The sound becomes monaural.
Press the button again to cancel the mode. “AUTO ST” will
be displayed on the main unit. Depending on the broadcast
system, stereo or monaural will be selected.
“MONO” is also canceled when you change the frequency.
≥ This setting can be preset for each broadcasting station.
SC-BT230_330_730P_PC_VQT2M13_eng.book 29 ページ ２０１０年３月１６日 火曜日 午後５時５７分