Panasonic BT-LS1400P - Manual (Page 10)

10
REMOTE specifications
Pin No.
1
2
3
4
5
6
7
8
9
Signal
Input switching function
Aspect ratio switching function
Standby function
Tally function
GND
s
s
s
s
5 4 3 2 1
9 8 7 6
Connector (9P)
In order to perform REMOTE operations, select ON as the
setting for the REMOTE menu item on the SYSTEM
CONFIG menu.
The functions for REMOTE operations can be switched by
opening or shorting the pins corresponding to the functions
to pin 5 (ground). There are two kinds of operations: level
operations and edge operations.
Level operations : The functions are operational while
the pins are shorted to pin 5 (GND).
Edge operations : The functions become operational
when the pins are transferred from an
open-circuited to short-circuited state
vis-à-vis pin 5 (GND).
The following four functions can be controlled externally.
≥ Input switching function (edge operations)
This switches the input from LINE A, LINE B, CMPNT
or SDI. The SDI signal input can be selected only
when the BT-YA210G, available as an optional
accessory, is installed. The input signals which have
been set to OFF (which are to be skipped) under the
INPUT SIGNAL menu item on the SYSTEM CONFIG
menu will not be displayed, thus making it impossible
for them to be selected.
≥ Aspect ratio switching function (level
operations)
This switches the aspect ratio.
≥ Standby function (level operations)
This blacks out the monitor while the power is on in
order to prevent images from being burned onto the
screen.
≥ Tally function (level operations)
This enables the tally lamp to light up red.
The tally lamp operates regardless of whether ON or
OFF is selected as the REMOTE menu item setting.
[MAINTENANCE]
RUNNING TIME 300H
RUNNING TIME
The total running time of the monitor is displayed here (in
hours).
¥ MAINTENANCE menu
The menu item shown below appears when the MAINTENANCE menu is selected on the main menu.
How to use the on-screen menus