Panasonic BT-LS1400P - Manual (Page 8)

8
[PICTURE MENU]
MODE BROADCAST
CONTRAST 60
BRIGHT 30
CHROMA 30
PHASE 30
SHARPNESS 30
AI OFF
NR OFF
COLOR TEMP D93
3D Y/C OFF
[LORD FACTORY]
MODE
The video mode is selected here.
≥ BROADCAST
This mode is set at the factory to best suit broadcast
operations.
≥ GENERAL
This mode applies the dynamic settings which were set
at the factory for generally receiving images.
≥ USER
This mode enables the mode set by the user to be
established. BROADCAST is the factory setting.
CONTRAST
The contrast can be adjusted here in line with the conditions
of the indoor work environment.
BRIGHT
The black level can be adjusted here.
CHROMA
The chroma level can be adjusted here.
Use the blue-only function to adjust the level while viewing
the SMPTE color bars.
PHASE
The phase can be adjusted here.
Use the blue-only function to adjust the level while viewing
the SMPTE color bars.
SHARPNESS
The appropriate sharpness in line with the signal
characteristics can be set here.
AI
Dynamic images can be received when this is set to ON.
NR
This is set to ON when the signal-to-noise ratio for the video
signals received is problematic.
COLOR TMP
The color temperature can be adjusted here.
The color temperature is adjusted to comply with the D65
and D93 standards at the factory.
For consumer products, the color temperature is normally
set higher.
3D Y/C
This is for the 3-dimensional Y/C separation function.
The picture quality is different when the function is ON and
when it is OFF.
LOAD FACTORY
This is selected when the factory settings are to be restored.
¥ PICTURE menu
The menu items shown below appear when the PICTURE menu is selected on the main menu.
How to use the on-screen menus
<Notes>
When any changes are made to the settings on this menu, the changes also take effect for the settings of other linked
video signals for some of the video signals which have been selected. How the changes are linked is explained below.
≥
Any changes made to the settings when the LINE A signal has been selected will also be made to the LINE B
signal. Conversely, any changes made to the settings when the LINE B signal has been selected will also be made
to the LINE A signal.
≥ When the optional SDI input unit (BT-YA210G) is installed, any changes made to the settings when the CMPNT
480i signal is selected will also be made to the SDI signal. Conversely, any changes made to the settings when the
SDI signal is selected will also be made to the CMPNT 480i signal.