Palsonic DVD/CD/MP3 Player DVD2030 - Manual (Page 31)

30
REMOTE NOT WORKING
Ensure the remote batteries are working.
Point the remote control directly at the player's IR
sensor.
Remove any obstacles between the remote and
the IR sensor.
UNIT NOT WORKING
Turn off the power, and then turn on again
Ensure the disc is not warped, damaged or deformed.
Ensure that the disc is not stained or damaged badly.
Ensure that the disc format is compatible to the player.
Please check whether you have tried to play a software CD,
if so, please restart the player.
"BAD DISC" DISPLAYED
Please read the user's manual carefully before using the DVD player. If you are having any troubles in using this
player, try to solve the problems by the suggestions mentioned below. If you can not correct the trouble after using
all the suggestions, please contact our company or the technical service centre authorised by us. For your safety,
DO NOT open the cover and attempt to repair the player yourself, it may cause electric shock.
NO DISC DISPLAYED
Ensure you have put the disc on the tray.
Ensure the disc is not upside down.
Ensure the disc is not distorted, stained or
scratched.
POOR PICTURE OR SOUND
Ensure you have set the player's of AUDIO settings correctly.
Ensure the disc is scratched or stained.
Ensure the AV connector or the output terminal is not
damaged.
SOUND BUT NO PICTURE
Ensure the video are securely connected.
Ensure you have ENTERED the correct AV input for your TV.
Ensure the video connector is not damaged.
Ensure you have set the player's VIDEO settings correctly.
PICTURE BUT NO SOUND
Ensure the audio jacks are securely connected.
Ensure the audio connector is not damaged.
Ensure the volume is turned up in VOL/CH setup.
Ensure you have set the player's AUDIO settings correctly
Ensure you have ENTERED the correct AV input for your TV.
Ensure that the audio is not set mute.
Ensure that the power button is on.
Ensure that the wall outlet is operational.
Ensure that the power cord is not damaged.
Ensure that the power plug is connected firmly to the
outlet.
NO PICTURE OR SOUND
Troubleshooting
Other
Specifications
Other
Power Requirements: 110-240V, 50/60Hz
Power Consumption: 15W
Video Standard: NTSC/PAL/AUTO
Unit Weight: 4.0lbs (1.8kg)
[Accessories]
Video/Audio cable x1
Remote Control x 1
User's Manual x 1
AAA Battery x 2
Specifications are subject to change without notice.
Weight and dimensions are approximate.
Video out
Video out: 1.0V(p-p)/75 , sync, negative polarity, RCA-pin Jack x1
S-Video output connector (separate Y, C signal output connectors)
Y output: 1.0V(p-p)/75 , sync, negative polarity
C output: 0.286V(p-p)/75
Audio out
5.1 channel out: 1.85V(rms)/10K , RCA pin jack (FL, FR, SL, SR
CEN, SW) x 6
Coaxial out: 0.5V(p-p)/75 , RCA pin jack x 1
Frequency response: 20Hz to 20KHz
S/N ratio: >90dB
Total harmonic distortion: <0.05%
This product incorporates copyright protection technology that is protected by method claims of certain U.S.
patents and other intellectual property rights owned by Macrovision Corporation and other rights owners.
Use of this copyright protection technology must be authorised by Macrovision Corporation, and is intended
for home and other limited viewing uses only unless otherwise authorised by Macrovision Corporation.
Reverse engineering or disassembly is prohibited.