Panasonic SC-PM313 - Manual (Page 10)

10
RQT7923
Cassette tapes – Play and record
Recording CDs Recording CDs
1 Insert the cassette to be recorded on.
B
B
Insert inside the
guides
Forward side
2 Press [CD 6] and then [STOP 7, –DEMO].
3 Press [ 0 OPEN/CLOSE] to insert the CD.
Press again to close.
4 Press [PLAY MODE] to select your desired mode
(refer page 7).
5 Press [ ¶/8 REC] to start recording.
Recording programmed tracks Recording programmed tracks
1 Program the tracks you want (refer page 8).
2 Press [ ¶/8 REC] to start recording.
Other basic operations Other basic operations
To Action
erase a recorded
sound 1) Insert the cassette to be recorded on.
2) Press [TAPE
3] and then [CLEAR 7].
3) Press [ ¶/8 REC].
stop recording Press [CLEAR 7].
stop recording
temporarily 1) Press [ ¶/8 REC].
2) Press again to resume recording.
to record on the
other side of the
tape Turn the cassette over and press
[
¶/8 REC].
Erasure prevention Erasure prevention
The illustration shows how to remove the tabs to prevent
recording. To record on the tape again, cover as shown.
Side A
Tab for side A Tab for side B
To re-record
Normal tape
Adhesive tape
Basic play Basic play
1 Press [OPEN 0] on top of the unit.
2 Insert a cassette.
B
B
Insert inside the
guides
Forward side
3 Close the lid by hand.
4 Press [ TAPE 3] to start play.
To play the other side of the cassette, turn the cassette
over.
To Action
stop tape playback Press [CLEAR 7].
start one touch play Press [TAPE 3] when the system is OFF
with the cassette loaded.
fast-forward and
rewind Press [4/REW/4] or [3/FF/¢] in the
stop mode.
TPS (Tape Program Sensor) TPS (Tape Program Sensor)
This function enables you to search the beginning of a track,
up to a maximum of 9.
Press [4/REW/ 4] or [3/FF/¢] during play.
Play resumes from the track found.
TPS may not function properly with:
• Short silent parts
• Noise occurs between tunes
• Silent parts found within tunes
Before recording Before recording
Preparation:
Wind up the leader tape so that recording can begin
immediately.
• Use normal position tapes.
• High position and metal position tapes can be used, but this unit
will not be able to record or erase them correctly.
Recording the radio Recording the radio
1 Insert the cassette to be recorded on.
2 Tune to the required station (refer page 11).
3 Press [ ¶/8 REC] to start recording.
Top of the unit
Cassette lid
PM31_7923-3P.indd 10 PM31_7923-3P.indd 10 2/18/05 3:25:18 PM 2/18/05 3:25:18 PM