Panasonic PV-D4743 - Manual (Page 10)

10 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]
Location of Controls (continued)
Rear View of DECK
AC Power Plug
S-Video Out
Connector
(DVD Only)
pp. 10, 13
Component Video Output
Connector (Y, P
B
, P
R
) (DVD Only)
p. 13
Audio Output 2
Connector (L/R)
p. 13
Optical Digital Audio
Output Connector
(DVD Only)
p. 15
Video Input
Connector
p. 35 Video Output
Connector
p. 12
Audio Output 1
Connector (L/R)
p. 12
VHF/UHF Antenna Input Terminal
p. 12
VHF/UHF Antenna Output Terminal
p.12
• While plugged into an AC outlet,
this DECK consumes 4 W of
electrical power in off mode.
• •
The following table shows the status of the output jacks when in VCR or DVD mode.
Bold: VCR Function Italic: DVD Function
Bold Italic: VCR and DVD Functions
Note • PROG functions on the remote are not available when using Component Video Output
and S-VIDEO OUT. Please set TV to either RF INPUT or VIDEO INPUT, and then press
PROG.
Video Output
Audio Out 1
Audio Out 2
Component
Video Output
S-VIDEO OUT
VCR
DVD
YES
YES
N/A N/A
To enjoy PROGRESSIVE SCAN video
(1). Connect Component Video Output to the component video input terminals of a television.
(See p. 13.)
(2). When the PROGRESSIVE button is pressed, the ON lamp lights up (see p. 9) and the
PROGRESSIVE SCAN signal is output from the Component Video Output Connector .
Note
• The PROGRESSIVE button can be operated when the DECK is in DVD function mode.
• The screen may shift off-center when using progressive output. Please adjust the screen
position if this occurs. (Refer to your TV manual.)
• The DECK outputs video signals (not PROGRESSIVE SCAN) from the “VIDEO OUT” and “S-
VIDEO OUT” terminals when the ON lamp is lit.
YES
Audio Input
Connector (L/R)
p. 35
D4743-4743S P1-25 (030226 B-lot).p65 2003/02/26, 19:53 10