Panasonic PV-D4743 - Manual (Page 48)

48 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]
• Make settings according to amplifier
connected to optical audio output as shown
in above table.
*1 When connecting an amplifier (with an
optical digital input connector) which does
not contain the Dolby Digital or DTS
decoder, be sure to select “PCM”.
If “Bitstream” is selected, starting DVD play
may cause such a high level of noise as to
be harmful to your ears and damage the
speakers.
*2 When a DTS decoder is connected, please
select “Bitstream” in “dts”.
Audio Output
Select the digital output to be output from the optical
digital audio output connector of DECK.
■ ■ ■ ■ ■ “LPCM (DVD)” selections
OFF: Linear PCM of less than 48 kHz/16 bit is
output. When playing DVDs recorded in linear
PCM of over 48 kHz/20 bit, no digital audio is
output. (Factory preset)
PCM: When playing DVDs recorded in linear PCM of
48 kHz/20 bit/24 bit or more, digital audio
converted to 44.1 kHz/16 bit or 48 kHz/16 bit is
output.
(Digital output of PCM audio is restricted to
48 kHz/16 bit or below for copyright protection.)
■ ■ ■ ■ ■ “Dolby Digital” selections
Bitstream: Dolby Digital bitstream (1ch-5.1ch) is
output. (Factory preset)
PCM: When you have connected a amplifier that
doesn’t have a built-in Dolby Digital decoder.
■ ■ ■ ■ ■ “dts” selections
Bitstream: DTS bitstream is output. (Factory preset)
PCM: When you have connected a amplifier that
doesn’t have a built-in DTS decoder.
■ ■ ■ ■ ■ “DRC (Dynamic Range Compression)”
selections
OFF: Normal audio range is selected. (Factory preset)
ON:
For dynamic sound even at low volume, this
is useful for late-night listening. [Dolby Digital
DVDs only].
Press
to select an item,
and
press
SET
repeatedly for
output. (See below.)
Press
to select
“AUDIO OUTPUT,”
and
press
SET
to display screen.
1
Settings for DVD Operation (continued)
3
2
4
Recommended setting
LPCM
( DV D )
P C M
P C M
P C M
Dolby
Digital
PCM* 1
Bitstream
Bitstream
D T S
PCM* 1
P C M
Bitstream
No amplifier is connected
AV amplifier (with digital
audio input connector)
without Dolby Digital/DTS
decoder
AV amplifier including
Dolby Digital decoder
AV amplifier including
Dolby Digital/DTS decoder
* 2
Type of amplifier
to be connected
Press ACTION to redisplay DVD MAIN
MENU and go to step 2 to setup another
item.
Or, press
ACTION twice to exit.
Press ACTION*
to display DVD MAIN MENU.
Ready Checklist
DECK is in DVD mode, press DVD.
DVD MAIN MENU
SELECT :
SET : SET
END : ACT I ON
D I SC LANGUAGES
AUDIO OUTPUT
ST I L L MODE : AUTO
TV MODE : 4 : 3 L e t t e r b o x
P A R E N T A L L O C K : L E V E L 8
AUD I O OUTPUT
SELECT :
SET : SET
END : ACT I ON
LPCM(DVD) : OFF
D o l b y D i g i t a l : B i t s t r e a m
d t s : B i t s t r e a m
DRC : OFF
D4743-4743S P36-60 (030226 B-lot).p65 2003/02/26, 19:53 48