Operating, E-22, Switch on the projector power – PLUS Vision V3-131 User Manual
Page 22: Switch on the power of the connected equipment, The projector is now capable of regular projection, Firmly plug in all the way. to wall outlet, Press the standby button, Button on main unit), The lens unit rises and projecting is now possible
E-22
STANDBY
AUTO
SOURCE
STANDBY
PUSH
STATUS
AUDIO
S-VIDEO
VIDE
O
RGB
Firmly plug in all the
way.
To wall outlet
Power Cable Connections and Switching the Power On/Off
There is an order in which the power cable is connected and the power is switched on/off.
Operating
3
Switch on the projector power
Press the STANDBY button.
Note:
The power will not turn on unless the lens unit is raised.
If the STANDBY button is pressed when the lens is stowed away, the
STATUS and STANDBY indicator’s flash orange for several seconds to
notify you that the lens is not raised.
The first time the power is switched on after purchase, [Menu
Language Select] will be displayed. See Page E-23 for infor-
mation about language selection.
• When the power is turned on, the STANDBY indicator starts
flashing green, then stops flashing after about 60 seconds. If
the STATUS indicator lights green at this time, the lamp mode
is set to “Eco”. See E-29 and 51 for instructions on selecting.
• If the power does not come on, see “When the STATUS Indica-
tor is Lit or Flashing” on Page E-57.
4
Switch on the power of the connected equipment
Note:
• When the power plug will be unplugged from the power outlet, please place the projector near the power outlet so that it may be reached
easily.
• Press the STANDBY button after the STANDBY indicator is lit in amber.
STANDBY
(button on main unit)
RGB
STANDBY
VIDEO
FREEZE
MUTE
ECO
AUTO
ASPECT
CANCEL
QUICK
MENU
ENTER
Q
1
2
3
4
2
ቢ Slide the lens shutter to the left until it stops.
ባ Press the lift button (marked “PUSH”).
The lens unit rises and projecting is now possible.
ST
AN
DB
Y
AU
TO
SO
UR
CE
ST
AN
DB
Y
ST
AT
US
PU
SH
1
2
1
Connect the AC IN connector of the projector and the power outlet using the supplied power cable.
The STANDBY indicator will light in amber, and the unit will enter the standby mode.
STANDBY
STATUS
STANDBY
STATUS
STANDBY
STATUS
This indicator is also lit green in Eco-mode.
Flashing green
(Approximately 60
seconds)
Lit green
Power is on
Lit amber
STANDBY
STATUS
Lit amber
If the “Password” input window is displayed: See E-34.
A password is set for this projector.
The projector cannot be used unless the correct password is in-
put.
To turn off the power: See E-24.
The projector is now capable of regular projection.