Planar WS231 - Manual (Page 4)

User’s Manual
iii
Important Safety Instructions
Please read the following instructions carefully. This manual should be
retained for future use.
1. To clean the LCD Monitor screen, first, make sure the Monitor is in the
power off mode. Unplug the Monitor from its power source before
cleaning it. Do not spray liquid cleaners directly onto the unit. Stand
away from the LCD Monitor and spray cleaning solution onto a rag.
Without applying excessive pressure, clean the screen with the slightly
dampened rag.
2. Do not place your LCD Monitor near a window. Exposing the Monitor to
rain, water, moisture or sunlight can severely damage it.
3. Do not place anything on top of the Monitor-to-PC signal cord. Make sure
the cord is placed in an area where it will not be stepped on.
4. Do not apply pressure to the LCD screen. Excessive pressure may cause
permanent damage to the display.
5. Do not remove the cover or attempt to service this unit by yourself. You
may void the warranty. Servicing of any nature should be performed only
by an authorized technician.
6. Safe storage of the LCD Monitor is in a range of minus 20 to plus 65
degrees Celsius (-4°F-149°F). Storing your LCD Monitor outside this
range could result in permanent damage.
7. If any of the following occurs, immediately unplug your Monitor and call
an authorized technician.
• The power or Monitor-to-PC signal cord is frayed or damaged.
• Liquid has been spilled onto the Monitor, or it has been exposed to
rain.
• The Monitor has been dropped or the case has been damaged.
8. The appliance should be disconnected from the mains by pulling the mains
power cord/mains plug.
9. The socket-outlet shall be installed near the equipment and shall be easily
accessible.