Panasonic AJ-HD1200A - Manual (Page 10)

32
SYSTEM
Item Setting
No.
Superimposed
display
No.
Superimposed
display
Description of settings
“ ” indicates the factory setting.
25 SYSTEM FREQ
0000
0001
2 0002
2 0003
2 0004
59/60
50i/25P
2 23/24
2 25 (HD)
2 25 (SD)
For selecting the system frequency
0: The 59.94 Hz or 60 Hz system frequency is selected.
1: The 50 Hz or 25 PsF system frequency is selected.
At this setting, the 1080/25 PsF format signals can be recorded and played back
in the same way as with the 1080/50i format.
2: The 23.98 Hz or 24 Hz system frequency is selected.
3: The 25 Hz system frequency is selected. However, black signals are output
from the SD SDI output and analog composite connectors.
4: The 25 Hz system frequency is selected. However, black signals are output
from the HD SDI output and analog component connectors.
<Note>
Merely changing this item’s setting only causes the menu item to flash, and the
setting itself is not reflected in the unit. To reflect a new setting in the unit, turn off
the power and then turn it back on.
26 HD SYS H ADV
0000
0001
0H
90H
For selecting the output whose HD output phase is to be advanced by 90H in
relation to the SD output.
0: Both the HD and SD signals are output in phase with the HD and SD REF
output signals.
1: The HD signals are output at a phase advanced by 90H from the SD output
signals.
When the SD REF signal is input, the REF input and SD output are in-phase,
and when the HD REF signal is input, the REF input and HD output are in-
phase.
<Notes>
O The audio signals and TC signal are output in phase with the HD output.
O With the 720p format, there is a phase difference of 120H between them.
O This item’s setting is fixed to “0H” when “1394” is selected as the menu item
No.600 [VIDEO IN SEL] setting or when an SD format tape is being played
back.
Setup menus
2 This appears when the AJ-YA120AG (optional accessory) has been installed.