Panasonic AJ-HD1200A - Manual (Page 25)

47
Setup menus
731 PB FADE
0000
0001
0002 AUTO
CUT
FADE
For setting the processing for the audio edit points (IN point, OUT point) and follow-
on recording point during playback.
0: The processing follows the status established during recording.
1: Cut processing is forcibly performed.
2: Fade processing is forcibly performed.
732 EMBEDDED AUD
0000
0001 OFF
ON
For setting whether to superimpose audio data onto the HD SDI output and SD SDI
output.
0: The audio data is not superimposed.
1: The audio data is superimposed.
759 DV PB ATT
0000
0001 OFF
ON
For selecting the audio output level during DV format playback.
0: The audio output level is not attenuated.
1: The audio output level is attenuated.
762 AUD RATE CON
0000
0001 OFF
ON
For setting whether the tape is to be played back without passing the signals
through the rate converter (without activating the digital filter) in the digital audio
output unit.
0: The tape is played back without passing the signals through the rate converter.
1: The signals are passed through the rate converter, and the tape is played back.
<Notes>
O In modes other than the 60 Hz mode, the signals are not passed through the
rate converter regardless of this menu item’s setting.
O ON/OFF control is exercised for channels 1 through 8 at the same time.
Separate settings cannot be performed on a channel by channel basis.
760 REC PT MUTE
0000
0001 OFF
ON
For selecting whether to mute the sound at the joins in the recording during DV or
DVCAM format playback.
0: The sound is not muted.
1: The sound is muted.
769 MONI SEL
0000
0001 PLY PCM
PLY CUE
For setting the monitor output sound during playback.
0: PCM sound is output.
1: CUE sound is output.
765 CUE OUT SEL
0000
0001
OFF
ON
For setting whether to output the analog CUE signal to the audio output (main line).
0: The analog CUE signal is not output.
During playback, PCM sound is output; in all other modes, no sound is output.
1: The analog CUE signal is output.
During playback, PCM sound is output; in all other modes, the analog CUE
signal is output.
AUDIO
Item Setting
No.
Superimposed
display
No.
Superimposed
display
Description of settings
“ ” indicates the factory setting.
730 REC CUE
0001
0002
0003
0004
0005
0006
0007
0008
0009
0010
0011
0012
0013 CH1
CH2
CH3
CH4
CH5
CH6
CH7
CH8
CH1+2
CH3+4
CH5+6
CH7+8
CH1~8
For setting the input signal to be recorded on the CUE track.
1: Audio input CH1 signal
2: Audio input CH2 signal
3: Audio input CH3 signal
4: Audio input CH4 signal
5: Audio input CH5 signal
6: Audio input CH6 signal
7: Audio input CH7 signal
8: Audio input CH8 signal
9: Audio input CH1 + CH2 mixed signal
10: Audio input CH3 + CH4 mixed signal
11: Audio input CH5 + CH6 mixed signal
12: Audio input CH7 + CH8 mixed signal
13: Audio input CH1 through CH8 mixed signal