Prince Castle TX Series - Manual (Page 2)

INSTALLATION
1. After you have removed the toaster from the
carton, inspect the unit for signs of damage. If there
is damage to the unit:
l Notify carrier within 24 hours after delivery.
l Save carton and packing materials for inspection
purposes.
l Contact the Prince Castle Customer Sales
Department at 1-630-462-8800 to arrange for
a replacement to be sent.
l Remove protective coating.
2. Verify that all parts have been received.
3. Locate toaster on a flat surface
4. Plug unit into the proper voltage receptacle.
OVERLAY GLOSSARY
ON/OFF Button: Turns Unit on and off.
SCAN UP/ACTUAL TEMP Button: When
pressed in run mode, display will show actual
platen temperature. In programming mode,
when pressed, will increase set point tempera-
ture.
SCAN DOWN Button: In programming mode,
when pressed will decrease the set point
temperature.
SET BUTTON: In run mode when pressed will
display the Set Point Temperature. In program
mode, when pressed, will store a new Set Point
Temperature.
OPERATION
1. Press On/Off Button, conveyor will begin to turn
and the display will read “LO”.
2. Once the toaster reaches its Set Point temperature
the display will read “R D Y” and the ACT LED will
be lit.
NOTE: When the toaster is turned OFF, if the platen is
above 450°F, the display will alternately indi-
cate “COOL” and “OFF” and the conveyor belt
motor will continue to run for up to 45 minutes
to protect the belt. When cooled sufficiently,
the display will go blank and the conveyor belt
motor will turn off.
2
PROG
ACT
SET
L O
PROG
ACT
SET
R D Y
PROG
ACT
SET
C O O L PROG
ACT
SET
O F F