Pioneer KEH-P4020R - Manual (Page 20)

Adjusting initial settings
Initial settings lets you perform initial set up of
different settings for this unit.
1 Press SOURCE and hold until the unit turns
off.
2 Press AUDIO and hold until STEP appears
in the display.
Press
AUDIO repeatedly to switch between the
following settings:
STEP — A-PI — AUX
Use the following instructions to operate each
particular setting.
• To cancel initial settings, press
BAND .
• You can also cancel initial settings by holding
down
AUDIO until the unit turns off.
Setting the FM tuning step
Normally the FM tuning step employed by seek
tuning is 50 kHz. When AF or TA are on the tun-
ing step automatically changes to 100 kHz. It
may be preferable to set the tuning step to 50
kHz when AF is on.
1 Press AUDIO to select STEP .
Press AUDIO repeatedly until STEP appears in
the display.
2 Select the FM tuning step with
2/3.
Pressing
2/3 will switch the FM tuning step
between 50 kHz and 100 kHz while AF or TA is
on. The selected FM tuning step will appear in
the display.
Note
• The tuning step remains at 50 kHz during
manual tuning.
Switching Auto PI Seek
The unit can automatically search for a different
station with the same programming, even dur-
ing preset recall.
1 Press AUDIO to select A-PI .
Press AUDIO repeatedly until A-PI appears in
the display.
2 Select A-PI on or off with
5/∞.
Pressing
5/∞ will switch
A-PI between on and
off and that status will be displayed.
Initial Settings
En 19