POSIFLEX Business Machines PP5600 SERIES - Manual (Page 15)

2 - 3
turning the ribbon feed knob of the
ribbon cartridge counterclockwise.
The ribbon must be properly tightened
to be able to set in position in
installation. Never turn the knob the
other way round or the ribbon may
mess up inside the cassette and ruin
the whole cassette.
•
If in process of replacing the
ribbon cassette, the cassette shall
be removed in the manner that the
side of the knob is pulled up first
with the end of the holding tab
remain held down.
•
Place the ribbon cartridge in
position as shown in the picture.
Seat the side with the holding tab
first then press down the whole
cassette. Rotate the ribbon feed
knob counterclockwise during the
action pressing down the ribbon
cartridge into position to help the
installation operation if necessary.
•
Turn the knob counterclockwise to
remove slack in
ribbon for use.
•
Apply even force
to close the auto
cutter (PP5600B)
so that the small
lug of auto cutter
can seat in right
position on the
Pressing this end
Pull up this end to remove
Seat this end first
Ribbon feed knob
Seat lug outside
bracket below
Fastening
Knob
š О