Paxar Rewind Monarch 415 - Manual (Page 22)

20. Recheck the printer to rewind alignment and fine adjust as
necessary.
21. Verify that the separator bars are located between the
strip as shown in Figure 19.
22. Verify that the labels on all three strips are aligned.
NOTE: All labels must be aligned as though the supply
was never separated to prevent torn strips or
labels coming off.
23. Turn the flange counterclockwise to take up any slack in
the strips.
24. Set the speed control knob to SLOW.
25. Turn on the rewind, operate the printer, and increase the
speed if necessary.
Label
Edges
Separator
Bars
Figure 19
Monarch 415 Rewind Operator’s Handbook
18