Pitco Frialator RS14D - Manual (Page 7)

PG14D: Floor Model Gas Pasta Cooker
INSTALLATION
3
1.3. LEG/CASTER INSTALLATION AND LEVELING
When you receive your appliance it is completely assembled with the possible exception of the legs
(or casters). This appliance must be installed with legs or casters; it cannot be curb mounted. Curb
mounting will seriously inhibit this appliance’s ability to effect proper component ventilation. The
legs/casters must be installed before connecting the appliance to the gas supply. The legs provide
the necessary height to meet sanitation requirements and assure adequate air supply to the
combustion system. Use the following procedure
Required tools: 7/16 “ wrench and socket and a large pair of water pump pliers.
1. Lay the appliance on its back, being careful not to damage the splash back by pulling on it.
Protect the outside of the appliance with cardboard or a drop cloth when laying it down.
2. Attach each leg/caster with the hex head screws and nuts supplied. Each leg/caster requires
four ¼-20 x 5/8” hex head screws and nuts. Insure that all screws are tight.
3. Mount the screws from the inside of the appliance with the nut on the outside (bottom) of the
appliance. The nuts have lock washers attached to them, therefore it is not necessary to use
separate lock washers.
4. When all four legs/casters are securely mounted, stand the unit up, being careful not to put too
much weight on any one leg. Adjust the height and level the appliance by adjusting the leveling
devices (B) with water pump pliers. On casters, loosen 2 screws (A) before leveling, make your
height adjustments, then retighten.
WARNING
DO NOT install legs or casters, or perform leveling procedure when
appliance is in operation or full of hot liquids. Serious injury could result.
WARNING
This appliance must be installed with the legs or casters provided by the manufacturer.