Panasonic AG-HMX100E - Manual (Page 37)

37
Basic Oper
ation
The following figure shows an example connection of
source equipment, PC, and this unit.
HMX100
SDI IN 3 SDI IN 4
DVI-I IN
AG-HMX100P/HMX100E
Professional-use
camera
PC
P2 mobile
SDI (video and
audio) input
DVI-I input
To execute DSK
DSK is executed with the DSK execution button.
1
Confirm that the DSK execution button is off.
2
Select the video connector to which input
video used for the key source to be inserted
and for the key fill fit in the key is output
( page Vol.2-11).
3
Press the DSK selector button.
You can preview output video to which the DSK is
inserted.
4
Set the detection level of the key video
by changing slice or slope setting
( page Vol.2-6).
5
Set the DSK transition time (from insertion start
to end) ( “To set the DSK transition time” on
this page).
6
Press the DSK execution button.
The button is lighted, and flashes while the key is
being inserted.
To use a transition pattern as DSK
Press the DSK EFFECTS button to turn on and select
a transition pattern instead of selecting preset video
( page 35).
The dissolve effect is applied.
 NOTE
It is impossible to use a pattern other than transition patterns
for DSK.
If a pattern unavailable for DSK is selected, the DSK EFFECTS
button flashes.
To set the DSK transition time
The currently set DSK transition time (DSK TIME) is shown
in the area where the event number, transition time, pattern
number, and internal video are displayed on the setting
screen ( page 20).
The factory default setting is [02:00
f
] (2 seconds).
1
Press the DSK setting button to turn on.
2
Set the DSK transition time by entering a
numeric value with the numeric keys or using
the TIME rotary control.
Example: To set “2:05” (2 seconds 5 frames),
enter “2.5.”
The [SYSTEM1] submenu of the [SETUP] menu can
be used to select the transition time display form
“seconds+frames” or “frames” ( page Vol.2-26).
3
Press the key.