Pioneer PRO-1120HD - Manual (Page 21)

06 Preparation
English
21
En
Cable connections for watching digital
and/or conventional TV channels
This system is equipped with two terminals for inputting TV
broadcasting signals: ANTENNA/CABLE A IN and ANTENNA B.
The ANTENNA/CABLE A IN terminal accepts both digital and
conventional TV broadcasting signals while the ANTENNA B
terminal accepts only conventional TV broadcasting signals.
When using a cable TV to watch digital and/or conventional TV
channels, connect to the ANTENNA/CABLE A IN terminal as
shown. In addition, you may connect an antenna to the
ANTENNA B terminal as shown; use an outdoor antenna to
enjoy clearer pictures. If your outdoor uses a 75-ohm coaxial
cable with an F-type connector, plug it into the antenna
terminal at the rear of the Media Receiver.
Connecting VHF/UHF antennas and a Cable
Converter
• Be sure to connect coaxial cables as shown above. Signal reception
may fail if not properly connected.
ANTENNA B IN
OUT
ANTENNA/
CABLE A IN
Media Receiver (rear)
Cable TV
Cable Converter
Cable connections for watching digital
TV channels over air (VHF/UHF)
If using VHF and UHF antennas to watch digital TV channels,
connect the coaxial cables as shown.
Connecting VHF/UHF antennas
ANTENNA B IN
OUT
ANTENNA/
CABLE A IN
VHF antenna UHF antenna
U/V mixer
Media Receiver
(rear)
Media Receiver (rear)
• Be sure to connect coaxial cables as shown above. Signal reception
may fail if not properly connected.
Splitter
Splitter