09 tuner setup, Naming tv channels, Checking signal strength – Pioneer PRO-1120HD User Manual
Page 32: Checking the cable card id, Enabling data acquisition
09
Tuner Setup
32
En
Naming TV channels
You can name TV channels that you have set up for antenna B.
This may help you easily identify the channels during selections.
1
Press HOME MENU.
2
Select “Tuner Setup”. ( / then ENTER)
3
Select “Channel Setup”. ( / then ENTER)
4
Select “Ant. B”. ( / then ENTER)
5
Select “Name Channel”. ( / then ENTER)
6
Select a channel. ( / then ENTER)
• You can also use buttons 0 – 9 to enter a channel
number.
Channel Setup Ant. B
Name Channel
Ant. B
Name Channel
xxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxx
Exit
Home Menu
7
Enter up to 7 alphanumeric characters using / ,
/ , and ENTER.
• To clear the last character, press B.
Channel Setup
Cancel
Ant. B
Name Channel
A
B C D E F G H
I
J
K L M N O P Q R S T
U V W X Y Z 1 2 3 4
5 6 7 8 9 0
. @ /
(
)
,
– _
:
'
&
S P A C E
Name: DTV2
Ant. B
Name Channel
xxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxx
Clear
Accept
Exit
Home Menu
D
B
A
8
Press A.
9
Press HOME MENU to exit the menu.
Checking signal strength
When you have selected antenna A, you can check the current
channel’s signal strength. You may use this function when
receiving a channel through a VHF/UHF antenna.
1
Press HOME MENU.
2
Select “Tuner Setup”. ( / then ENTER)
3
Select “Channel Setup”. ( / then ENTER)
4
Select “Ant. A”. ( / then ENTER)
5
Select “Signal Strength”. ( / then ENTER)
Channel Setup
Exit
Ant. A
Signal Strength
Ant. A
Current: 100
Maximum: 100
xxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxx
Home Menu
Signal Strength
• Adjust the direction of the antenna so that the current
signal strength reaches as close to the maximum signal
strength as possible.
6
Press HOME MENU to exit the menu.
Checking the Cable Card ID
The Media Receiver has a slot for a cable card that is used for
managing your information by the cable TV company. The
following procedure allows you to check your Cable Card ID and
the Host ID.
1
Press HOME MENU.
2
Select “Tuner Setup”. ( / then ENTER)
3
Select “Channel Setup”. ( / then ENTER)
4
Select “POD ID”. ( / )
• The Host ID and Cable Card ID appear.
5
Press HOME MENU to exit the menu.
Enabling data acquisition
Use this function to enable the system to automatically acquire
information about digital TV programs even when in the standby
mode.
1
Press HOME MENU.
2
Select “Tuner Setup”. ( / then ENTER)
3
Select “Channel Setup”. ( / then ENTER)
4
Select “Data Acqu”. ( / then ENTER)
5
Select “Enabled”. ( / then ENTER)
6
Press HOME MENU to exit the menu.
• The DATA ACQUISITION indicator on the front of the Media
Receiver lights while data is being acquired.