Panasonic SL-SX240 - Manual (Page 3)

3
Button Display/reference Operation
To pause play
To stop play
To turn off the
unit
Skipping
tracks
Searching
through tracks
Off mode
Stop mode
Sequential Play
Basic Play
Follow steps 1–5.
In step 2: Connect the stereo earphones and the wired remote control to the headphone jack [ Ë ]. (Plug in firmly.)
In step 5: The volume range is 0-25. (Press and hold to change the volume successively.) The volume changes
when pressed while the level is displayed. If any other display is shown, it changes to show the current
level. (The volume returns to 10 when you disconnect the power source.)
≥ Play stops automatically when all the tracks have been played.
≥ If the unit has been connected to the car audio system, set this unit’s volume to 10, then adjust the volume level on the system.
≥ During program play (page 4), these buttons are
used to skip forward or back through the pro-
grammed sequence of tracks.
≥ You cannot skip to tracks that have been played
in random or random repeat play (page 4).
≥ During program play, 1-track repeat play, random
play and random repeat play (page 4), search op-
eration is limited to the current track only.
Press during play.
Press during play.
Press during stop
mode.
Press during play.
(Press [
: ] twice to skip to the
beginning of the previous tracks.)
Press again to restart play.
Press and hold during play.
2
3
1
5 4
OPEN
HOLD
VOL
VOL
S-XBS
VOL
TRAIN TRAIN
ALL ALL
RANDOM RANDOM
SORR SORRY
1 M
C
S-XBS
VOL
TRAIN TRAIN
ALL ALL
RANDOM RANDOM
SORR SORRY
1 M
C
O
P
R
OF
F
L R
S-XBS
VOL
TRAIN TRAIN
ALL ALL
RANDOM
SORRY
1 M
C
O
P
R
O
FF
S-XBS
VOL
TRAIN TRAIN
ALL ALL
RANDOM
SORRY
1 M
C
S-XBS
VOL
TRAIN TRAIN
ALL ALL
RANDOM RANDOM
SORRY
1 M
C
O
P
R
O
FF
Label must face upward.
Elapsed playing time
of each track
Track number in play
Total number of tracks
Total playing time
Backward
Forward
HOLD Function
To use the HOLD function
Set [HOLD] to the HOLD position.
“ ( ” indication
When the unit is in HOLD mode, pressing any button
causes the indication “
( ” to appear on the display.
When the unit is powered off
The “
( ” indication appears only when [ 1; ] (main
unit) is pressed.
HOLD
HOLD
Before operating the buttons
Be sure to move [HOLD] to release the unit from the
HOLD mode.
HOLD mode
This function causes the unit to ignore short, accidental
button presses. (The disc lid can still be opened and
closed.)
The HOLD function prevents the following:
≥ The unit is powered on accidentally when not in use,
causing the batteries to run down.
≥ A button is accidentally pressed during play, interrupt-
ing the operation.
The unit and wired remote control have HOLD func-
tions, each of which works independently.
Plug type:
3.5 mm stereo
Resume function
The player stores the track where you stopped play and
if you press [
1 ; ] (main unit) or [ ∫ / 1 ] (remote control)
play resumes from the beginning of the track.
The resume function is canceled (play starts from the
first track) if you open the lid when the unit is in stop
mode. It is also usually canceled when you replace the
CD while the unit is off.
Note !
≥ The resume function may work if you replace the CD
while the unit is off.
≥ If you turned the unit off near the end of the track, play
may resume from the beginning of the next track.
≥ The resume function works automatically and cannot
be turned off.
Removing discs
1 Press [ ∫ ,OPR OFF] to stop play and disc rota-
tion.
2
Slide [OPEN 1 ] to open the lid.
3
Press [PUSH] to release the disc.
Do not stop the disc by hand or try to remove it before it
stops rotating. This can damage CDs.
Note 1
Never insert foreign objects into the unit body.
Auto power off function
If you leave the unit in stop mode for about 10 minutes
(30 seconds if disc isn't loaded), it turns off to save the
batteries.
For your reference:
“ ” indication
This indication appears for about 30 seconds if [ 1; ] (main unit) or [ ∫ / 1 ] (remote control ) is pressed
when no disc is loaded in the unit or if the disc is not properly secured.
“
* ” indication
This indication appears for about 10 minutes when the lid is opened. (However, the indication does not appear when
the unit is powered off.)
PU SH
PUSH
SL-SX280
SL-SX280
SL-SX280
Note on CD-R and CD-RW
This unit can play CD-DA format audio CD-R and
CD-RW that have been finalized
§ upon completion
of recording. It may not be able to play some CD-R
or CD-RW due to the condition of the recording.
§ Finalizing is a process that enables CD-R/CD-RW players
to play audio CD-R and CD-RW.
Decrease
Increase
SL-SX280
Close the lid.