Panasonic NV-MV40GL - Manual (Page 6)

6
Tuning the TV to Your VCR
The VCR supplies a signal to the TV via the RF coaxial cable
on channel AU28-69 or NZ21-69.
It is possible to view the video picture on your TV in the same
way that you watch TV broadcasts.
If you have connected the VCR to the TV through the Audio/
Video input sockets, then you do not need to follow the
procedure below.
Preparation
• Turn on the TV and the VCR.
Operations
1 Hold down [MENU]
(7) for 5 seconds or more.
2 Set the TV to an unused position which you wish to
use for your video playback.
• Tune the TV until the display
shown on the right appears on
the screen. (Please refer to the
TV manufacturers operating
instructions regarding tuning.)
3 Press [MENU] (7).
To Change the RF output Channel
In some rare cases after tuning the TV to your VCR,
interference may be visible on the picture. To get rid of this
interference, you can manually adjust the RF output channel a
few channels up and down from the current setting. The
procedure is described below.
Operations
1 Hold down [MENU]
(7) for 5 seconds or more.
• The VCR display changes as shown below and the VCR
picture on the TV displays this pattern.
2 Enter the desired channel number (AU28-69, NZ21-69)
by [Numeric] (2) or [Channel] (32).
• Ensure that [VCR/TV] switch (22) is set to [VCR].
• Set the RF output channel of the VCR to [ ss] (RF OFF)
when the VCR is connected to the TV via the Audio/Video
cable.
Press [Channel]
(32) to display [ ss].
• It is also possible to select by pressing [Numeric] (2)
Example:
3 Press [MENU] (7) to finish the setting mode.
4 Retune your TV to the new RF channel for the VCR.
Note:
• Even if the RF output channel has been changed, it is not
necessary to perform Auto Tuning.
Panasonic VCR
END: MENU
Panasonic VCR
END: MENU
28 37
ss
… … 69 21E … 69E
(Initial position)
For New Zealand For Australia
(RF OFF)
2 8 28: