Polk Audio Digital Solution System - Manual (Page 6)

Polk Customer Service (800) 377-7655 6
Carton Contents
Your new Polk Audio Digital Solution system comes in multiple car-
tons. If you do not have any of the pieces listed below, or if any com-
ponent seems damaged, contact your Polk Audio retailer immediately.
Two (2) front channel speakers
Two (2) surround channel speakers
One (1) center channel speaker
One (1) subwoofer with built-in 6 channel amplifier
One (1) Digital Solution Preamp/Processor
One (1) Infrared remote control
Two (2) AA batteries for remote
Three (3) 20' (6M) speaker cables
Two (2) 40’ (12M) speaker cables
One (1) 4 Meter DB-25 interconnect cable
One (1) AM loop antenna
One (1) FM dipole antenna
One (1) FM antenna connector
Quick Start Guide (see illustrations on pages 8 and 9)
1. Remove all of the components and accessories from the
shipping cartons.
2. Connect sources such as DVD player, VCR, etc. to the
Digital Solution audio and video inputs using coaxial
(RCA-type) cables.
3. Connect the VIDEO TV output of the Polk Digital Solution
preamp processor to a video input on your TV.
4. Connect the preamp/processor to the subwoofer with the
supplied 4 meter DB-25 cable.
5. Using the supplied speaker wires, connect the speakers to the
speaker terminals on the back of the subwoofer. Be sure to
maintain correct polarity ( + to +, - to -) on all channels.
Wires with a red band should always be connected to red
terminals on the speakers and amplifier.
6. Plug the AC cords from the preamp/processor and subwoofer
into 120V/60 Hz AC power outlets.
7. Turn the power switch on the subwoofer to the
“Standby” position.
8. Press the power button on the preamp/processor front panel
or remote control.
9. Select the input of your choice.
10. Set volume and bass level to taste and enjoy!
GETTING STARTED
DIGITAL SOLUTION DIGITAL PREAMP / PROCESSOR
BASIC SETUP