PS Audio POWERPACK 1500 MKII - Manual (Page 20)

4826 Sterling Drive, Boulder, CO 80301
PH: 720.406.8946 [email protected] www.psaudio.com
®
Getting Started 20
©2009 PS Audio International Inc. All rights reserved.
Installation & Operating Instructions
Owner’s Reference PowerPack 1500 MKII
1.Remove the two screws from the vented door on the front panel.
2.Remove the vented door from the panel.
3.Remove the screws on left and right sides of battery drawer.
4.Slowly pull out the battery drawer.
5.Connect the black wire to the Negative (-) terminal of battery B (There may be a large
spark when batter connections are made).
6.Slowly push the battery drawer into the UPS.
7.Replace and tighten the screws on left & right sides of battery drawer.
8.Replace the vented door.
9.Replace and tighten screws to secure the vented door.
1.Remove the two screws from the vented door on the front panel.
2.Remove the vented door from the front panel.
3.Remove the screws on left and right sides of battery drawer.
4.Pull out the battery drawer.
5.Connect batteries A & B in series by connect the Negative (-) terminal of battery A to
the Positive (+) terminal of battery B with the included battery connecting cable.
6.Put the two batteries inside the battery drawer.
7.Connect the red wire to the Positive (+) terminal of Battery A.
8.Connect the black wire to the Negative (-) terminal of Battery B.
(There may be a large spark when batter connections are made)
9.Slowly push the battery drawer into the UPS.
10.Replace and tighten the screws on left & right sides of battery drawer.
11.Replace the vented door
12.Replace and tighten crews to secure the vented door.
Screws
Battery A
Battery B
+
-
Battery drawer
2.8 Instructions
for first time use
2.9 Instructions
for battery
replacement