PS Audio POWERPACK 1500 MKII - Manual (Page 8)

4826 Sterling Drive, Boulder, CO 80301
PH: 720.406.8946 [email protected] www.psaudio.com
®
Getting Started 8
©2009 PS Audio International Inc. All rights reserved.
Installation & Operating Instructions
Owner’s Reference PowerPack 1500 MKII
2. Calculate the sum of all the V x A ratings. (Input voltage/current show on
the device or listed in the manual).
3. Ensure that the total VA rating does not exceed the rated capacity of the UPS.
If rated unit capacities are exceeded, an overload condition may occur and
cause the UPS unit to shut down or the circuit breaker to trip.
Connect the Load
Plug your primary equipment into the Battery Power Protected outlets. Leave
the power switches of the equipment in the “off” position for the moment.
Connect to PowerPlay
Use the enclosed RS-232 (DB9) to AppleTalk cable. Plug the 9-pin male end
into the UPS. Plug the 3-pin male end into the UPS port on your PS Audio
Power Conditioner.
• Note: Please check with your local dealer for the monitoring services.