PYLE Audio PLPK5TVD - Manual (Page 9)

GENERAL OPERATION
• ON/OFF
Switch on the unit by pressing PWR button (1). When system is on, press it again
to turn it off.
• FACEPLATE RELEASE
Press REL button (2) to draw out the faceplate, push the panel to draw in.
When the faceplate is drawn out, turn the faceplate upward and adjust TV display.
• SELECTING SOUND MODE
Press SEL button (6) to move display through volume, bass, treble, balance and
fader functions. Use (7) and (8) buttons to adjust the selected mode.
When mode has not been adjusted for several seconds, display returns to previous
display status.
Volume
Adjust volume level using (7) and (8) buttons.
Bass
Press SEL button (6) for one time. Adjust bass level using (7) and (8) buttons.
Treble
Press SEL button (6) for two times. Adjust treble level using (7) and (8) buttons.
Balance
Press SEL button (6) for three times. Adjust sound balance between left and right
speakers using (7) and (8) buttons.
Fader
Press SEL button (6) for four times. Adjust sound balance between front and rear
speakers using (7) and (8) buttons.
• SELECTING PLAYING MODE
When the screen display is drawn out, the unit would automatically switch into TV
mode. By pressing MOD button (12), you can select desired playing mode among
TV and radio.
CAUTION: The unit cannot be switched into TV mode, when the car is running.
So at this time, you just select playing mode in radio.
• MUTE
Press MUT button (3) to cut down sound output, “MUTE” appears on display.
Press it again to resume the previous volume level.
• SETTING THE CLOCK
Press T/F button (5) to change the display into clock display. While the current time
is appeared on the display, press it again to return to frequency showing.
9
VOL BAS TRE BAL FAD
(Volume) (Bass) (Treble) (Balance) (Fader)