Pioneer DOUBLE-DIN DVD NAVIGATION SYSTEM AVIC-D2 - Manual (Page 109)

107
A
ppe
ndi
x
NA
VI/
A
V
Appendix
Installing the Program
The program is installed to the navigation system
using the application disc.
This is not necessary if your dealer already
performed the installation.
When installing the program, you carry out the
following operations. When all the setup proce-
dures are completed, you can use the navigation
system.
1
Park your vehicle in a safe place.
Leave the engine on, and make sure that the
parking brake is applied.
2
Insert the Pioneer DVD Map Disc into the
DVD-ROM loading slot of the navigation
system.
When the upgraded program has been found,
installation of the program starts immediately.
❒ Do not insert anything other than a disc
into the DVD-ROM loading slot.
❒ If you cannot insert a disc completely or if
an inserted disc is not recognized, check
that the label side of the disc is up. Press
the DVD-ROM EJECT button to eject the
disc, and check the disc for damage before
inserting the disc again.
• Once the installation of the program starts,
do not stop the engine of your vehicle nor
switch off the navigation system until the
installation is completed and the following
Audio screen appears.
3
Press the MAP button to change the navi-
gation screen.
4
Touch “Yes/Oui”.
When you start the navigation system for the
first time, you will see a confirmation message
asking if you wish to select another language.
English is the default language of the naviga-
tion system. If desired, you can select another
language as shown.
❒ To keep English, touch “No/Non”. After
this, proceed to Step 7.
❒ When you want to select another lan-
guage, touch “Yes/Oui”, and proceed to
the next step.
5
Select the language from the list.
Touch the language you want to use.
❒ The language selected here is reflected for
the Navigation functions (e.g., Destination
search, etc.) only.
➲ To change the language ➞ Page 64
Installation of the program, in the language
you chose, begins.
1
Insert the disc while the vehicle is
parked.
2
Select the language used for the navi-
gation system.
3
Setting the clock.