Perle Systems S-110P - Manual (Page 11)

Perle PoE/PoE+ 10/100 Ethernet Media Converter
11
Disabled: The loopback feature is disabled. This is default
position for normal operation. The switch must be set to this
position in order for data to pass through the media
converter.
Enabled: This is a test mode. All data received on the
receive (RX) fiber connection is looped back to the transmit
(TX) fiber connection. The data link will be disabled;
however power to the powered devices will be maintained.
This mode will override all other switch settings.
Bank 2
Speed Copper (Switch 1)
Switch Position Copper port
Up (default) 100
Down 10
100: When Switch 1 is in the Up position, the S-110P will
force the speed to 100 Mbps.
10: When Switch 1 is in the Down position the media
converter will force the speed to 10 Mbps.
Duplex Copper (Switch 2)
Switch Position Copper port
Up (default) Full Duplex
Down Half Duplex
Full Duplex: In the Up switch position; the media converter
will be set to Full Duplex mode.
Half Duplex: The media converter will be set to Half Duplex
mode.