Perle Systems S-110P - Manual (Page 7)

Perle PoE/PoE+ 10/100 Ethernet Media Converter
7
DIP Switch Settings
Bank 1
Auto-negotiation (copper) (Switch 1)
Switch Position Copper Port
Up (default) Auto
Down Off
Note: Auto-negotiation should only be turned off, if the
copper link partner does not support Auto-negotiation and
fixed settings are required by the copper link partner.
Auto: When enabled, the media converter will negotiate
with its link partner to determine the most optimal
parameters for this connection. The S-110P will advertise
capabilities of 10 and 100 Mbps, full and half duplex as well
as pause to the link partner.
If the copper link partner does not support Auto-negotiation,
the S-110P will parallel detect to 10 or 100 Mbps and force
Half Duplex mode as per IEEE specifications.
Off: When the Auto-negotiation switch is set to the OFF
position, the media converter will not negotiate the Ethernet
parameters with the copper link partner. The parameters
used by the media converter will be determined by the
Copper Speed (Bank 2 - switch 1) and Duplex Copper (Bank
2 - switch 2) DIP switch settings. Pause receive and send
will be disabled.
Link Pass-Through Mode (Switch 2)
Switch Position Mode
Up (default) Standard Mode
Down Link Pass-Through Mode