Panasonic NV-FJ600 - Manual (Page 6)

6
Setting the Remote Control to Operate Your TV
TV Operation
The explanations below show you what functions individual
buttons have when the VCR/TV switch R is set to “TV”.
1 POWER button
To switch the TV on from standby mode (OFF) or vice
versa.
On some TVs it is only possible to switch the TV to standby
mode (OFF) with this button, but not on. In this case, try to
turn the TV on with one of the following buttons:
Numeric buttons 2
AV button 3
Channel button P
2 Numeric buttons
To select the programme positions (1–99) on the TV.
3 AV button
To select the desired AV input on the TV.
O VOLUME button
To adjust the volume of the TV.
P Channel button
To select the desired programme position (TV station) on
the TV.
01 Panasonic/National
02 Panasonic/National
03 Panasonic/National
04 Panasonic/National
05 SONY
06 TOSHIBA
07 JVC
08 HITACHI
09 MITSUBISHI
10 MITSUBISHI
11 SHARP
12 PHILIPS, SAMSUNG
13 NEC
14 SANYO
15 GOLDSTAR/LG
16 GOLDSTAR/LG
17 SAMSUNG
18 SAMSUNG
19 SANYO
Notes:
≥ If you are using a Panasonic TV, this setting has already
been made, and so you do not need to perform the above
setting procedure. However, this remote controller may not
work with some Panasonic TVs.
≥ Some TV models cannot be operated using this remote
controller (including all TVs non-remote compatible).
You can operate the TVs of the manufacturers listed below
with the remote controller after setting it.
This setting procedure allows you to operate the TVs of some
manufacturers using the supplied remote controller.
Preparation
≥ Set the VCR/TV switch R to “TV”.
Operations
1
Find the manufacturer number of your TV while
referring to the following table.
2
While holding down the POWER button 1 , use the
Numeric buttons 2 to enter the manufacturer
number. This completes the settings for the TV
manufacturer.
≥ Be sure to enter the number in two digits.
Example: 1 jjN 01
3
To confirm the correct settings were made, check
whether the TV can be operated properly.
≥ When a manufacturer has multiple numbers in the
following table, tr y entering other numbers if the TV
operations cannot be performed properly, and then
select the optimal number.