Panasonic NV-FJ600 - Manual (Page 9)

9
Setting Up
To Change the RF Output Channel
In some rare cases after tuning the TV to your VCR,
interference may be visible on the picture. To get rid of this
interference, you can manually adjust the RF output channel
a few channels up and down from the current setting. The
procedure is described below.
Operations
1
Hold down MENU button V for 5 seconds or more.
≥
The VCR display changes as shown below and the
VCR picture on the TV displays this pattern.
2 Enter the desired channel number (AU28-69, NZ21-69)
by the Numeric buttons 2 or the Channel button P.
≥
Ensure that the VCR/TV switch R is set to “VCR”.
≥ Set the RF output channel of the VCR to “ss” (RF OFF)
when the VCR is connected to the TV via the Audio/
Video cable.
Press the Channel button
P to display “ss”.
Example:
3 Press the MENU button V to finish the setting mode.
4 Retune your TV to the new RF channel for the VCR.
Note:
≥ Even if the RF output channel has been changed, it is not
necessary to perform Auto Tuning.
Panasonic VCR
END:MENU
RF SELECT BG I ≥ DK
RF SELECT:
Example for NV-FJ600A Example for NV-FJ600EA
For NV-FJ600EA For NV-FJ600A
(RF OFF) (RF OFF)
2 8 28:
28
ss
… 69 21
ss
… 69
Auto Tuning Using the On Screen Display
The VCR is tuned automatically by the operations on page 8.
However, Auto Tuning using the On Screen Display should
be performed according to the following method if necessary.
Preparations
≥ Confirm that the TV is on and the VCR viewing channel is
selected.
≥ Turn on the VCR and select any programme position
except A1 or A2.
Operations
1
Press the MENU button V to
display the Main menu on
the TV screen.
2 Press the Cursor buttons (34 34 34 34 34 ) T
to select “TUNER PRESET” then
press the ENTER button U.
3 Press the Cursor buttons (34 34 34 34 34 ) T
to select “AUTO TUNE” then press
the Cursor buttons (2 1
2 1 2 1 2 1 2 1 ) T to
start the Auto Tuning.
≥
When Auto Tuning is
completed, the On Screen
Display disappears and
programme position 1 is
selected.
Note:
≥ If the VCR is not correctly tuned by Auto Tuning, follow the
procedure on the next page.
LANGUAGE
CLOCK SET
TUNER PRESET
CH ADD&DELETE
G-CODE CH SET
SYSTEM
OPTION
SELECT
END : ,ENTER
:MENU
MENU
CH 1
CLEAR
(OFF)
AUTO TUNE
SEARCH
(3)
FINE
LANGUAGE
CLOCK SET
TUNER PRESET
CH ADD&DELETE
G-CODE CH SET
SYSTEM
OPTION
SELECT
END : ,ENTER
:MENU
MENU
END :MENU SELECT:
TUNER PRESET
CH 1 SEARCH
END: MENU
100 µ
AUTO TUNING
IN PROGRESS,
PLEASE WAIT.
The number displayed here is
the number of channels still
to be auto tuned.
Channels that can be Received
NV-FJ600A 0 –12 45– 470MHz 28 –69
NV-FJ600EA 1 –11 45– 470MHz 21 –69
VHF CATV UHF