Palsonic DVD3000 - Manual (Page 12)

Basic connection
Set the power switches on the player and equipment to be connected to OFF beforeconnecting.
l Read through the instruction for the equipment to be connected.
l Be sure that the colors of the connectors and plugs match up when connecting the cord.
Connecting to a TV with stereo sound
1. TV set (optional)
2. DVD player
3. Audio/Video cord (supplied)
4. S-video cord (optional)
5. To audio input connectors (red, white)
6. To video input connector (yellow)
7. To S-video input connector*
8. Power cord to power outlet (AC 110-240V, 50/60 Hz)
Connecting to an audio equipment
1. Audio equipment (optional)
2. TV set (optional)
3. DVD player
4. Audio cord (optional)
5. To audio input connectors (red, white).
6. Video cord (optional)
7. S-video cord (optional)
(See mentioned above)
Note:
When the above connection is made, you must change “CNTR and REAR SPEARER” , “SUBWOOFER”
setting to “OFF”. (refer to page 21)
Notes:
l During DVD playing, the TV volume may be at a lower level than during TV broadcast. If this is the case,
adjust the volume to the desired level.
If the DVD player is connected to the TV through a video cassette recorder, the picture may not be played
back normally with some DVD discs. If this is the case, do not connect the player via the VCR.
*The S(separate) video output connector separates the chrominance (C) and luminance (Y) signals before
transmitting them to the TV set in order to achieve a sharper picture.
Use the S-video cord (optional) when connecting the player to a TV set equipped with an S-video input
connector for the best picture clarity possible.
Caution for connection of digital audio output terminal:
On “DIGIT AL AUDIO OUT” terminal, don’t connect amplify without Dolby AC-3 decoder. Otherwise, the
attempt to play DVD discs may cause a high level of noise that it may be harmful to your ears and damage
your speakers.
l
Optional audio connection
Connecting to an AC-3amplifier or an AC-3 decoder 5. connect to RF input terminal of AC-3 decoder (optional)
1. TV set (optional) 6. direct connect to 5.1ch amplifier .
2. DVD player With connecting to 5 or 6 (optional one), When DVD
3.Audio/Video cord (supplied) S-video cord (optional) discsrecorded in Dolby Digital Surround are played, you
can enjoytheater-quality audio right in your home.
10
A
A B
C
l
l
4. AC-3 decoder
l