Planet Technology XRT-104D - Manual (Page 35)

30
Edit a QoS rule Select the rule you want to edit and click “Edit”, then you will
enter the detail form of the QoS rule. Click “Save” after editing
the form and the rule will be saved.
Adjust QoS rule priority You can select the rule and click
“Move Up” to make its priority
higher. You also can select the rule and click “Move Down” to
make its priority lower.
QoS Rule:
You can assign packet classification criteria by its source IP range, source MAC address,
destination IP range, traffic type, protocol, source port range and destination port range
parameters. The parameters that you leave as blank will be ignored. The priority of this rule will
be applied to packets that match classification criteria of this rule. You can limit bandwidth
consumed by packets that match this rule or guarantee bandwidth required by packets that match
this rule. You also can assign which WAN port that the packets matching this rule can go through.
Parameter
Description
Rule Name
The name of this rule.
WAN Port
Select the WAN ports that the packets matching this rule can go
through.
Bandwidth
You can assign the bandwidth by the unit of Kbps (1024 bit per
second). You can limit the maximum bandwidth consumed by
this rule by selecting
“Maximum”. You also can reserve enough
bandwidth for this rule by selecting “Guarantee”.
Source Address
You can select IP or MAC address as the source address criteria.
Source MAC Address
Enter the MAC address of the packet that this rule will apply to.