Planet Technology XRT-104D - Manual (Page 32)

27
3.2.8 QoS You can specify rules for bandwidth control.
3.2.9 DNS
You can specify a DNS server that you wish to use
3.2.10 DDNS
You can specify a DDNS server that you wish to use and
configure the user name and password provided by you
DDNS service provider.
Once you have made a selection, click <More Configuration> at the bottom of the screen and
proceed to the manual
’s relevant sub-section.
3.2.1 Dynamic IP
Choose the Dynamic IP selection if your ISP will automatically give you an IP address. Some
ISP
’s may also require that you fill in additional information such as Host Name, Domain Name
and MAC address. (see chapter 2 “Cable Modem” for more detail)
3.2.2 Static IP Address
Select Static IP address if your ISP has given you a specific IP address for you to use. Your ISP
should provide all the information required in this section. (See chapter 2
“Fixed IP” for more
detail)
3.2.3 PPPoE (PPP over Ethernet)
Select PPPoE if your ISP requires the PPPoE protocol to connect you to the Internet. Your ISP
should provide all the information required in this section. (See chapter 2
“PPPoE” for more detail)
3.2.4 PPTP
Select PPTP if your ISP requires the PPTP protocol to connect you to the Internet. Your ISP
should provide all the information required in this section. (See chapter 2
“PPTP” for more detail)
3.2.5 L2TP
Select L2TP if your ISP requires the L2TP protocol to connect you to the Internet. Your ISP
should provide all the information required in this section. (See chapter 2
“L2TP” for more detail)
3.2.6 Telstra Big Pond
Select Telstra Big Pond if your ISP requires the Telstra Big Pond protocol to connect you to the
Internet. Your ISP should provide all the information required in this section. Telstra Big Pond
protocol is used by the ISP in Australia. (See chapter 2
“Telstra Big Pond” for more detail)